|
|
(3 intermediate revisions by the same user not shown) |
Line 1: |
Line 1: |
| '''HarryMann:''' Steering/Wheel Alignment sign conventions and notes
| |
|
| |
|
| Camber +ve Should be top of wheel leaning out c.f. bottom
| | See [[Steering and Suspension Alignment| Steering geometry/alignment]] for more detailed information... |
| | |
| Caster + ve The steering axis of left front wheel slopes from bottom left to top right; right front wheel, from bottom right to top left. This would usually be the angle of a Maccy strut or the angle between the upper and lower ball joints; the actual point of contact Vs the camberline is not taken into account, just the angle, whether it leads or trails
| |
| | |
| Toe +ve Toeing-in. For front: Toe-in sensitises the steering and toe-out de-sensitises it (e.g. whitelining) This due to the ackerman steering geometry, if you think about it.
| |
| | |
| Then there's SAI (Steering Axis inclination), like caster but viewed from the front.
| |
| | |
| Scrub Radius/Kingpin Offset - preset. VW were early adopters of -ve scrub radius (allowing you to be totally unaware of a tyre going flat - great!)
| |
| | |
| Note: The slope of whole van, front to rear can affect caster, but is usually not adjustable. Heavy slope has more effect on roll-centres than caster, with regard to handling (witness overloaded Paddy Pickups swaying all over the road, also contributed to by under-inflated rears Vs fronts, for the load carried - Grandma, Grandad, 8 kids and 3 tons of knocked-off sand and cement)
| |
Latest revision as of 23:15, 4 December 2008