Diesel engine wiring

From VW T25(T3)-Tech
Revision as of 13:26, 2 October 2013 by HarryMann (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

Diesel Engine wiring

Black Box in engine bay

There is a Black box on the left hand forward side of the engine bay (junction box). This contains most of the wiring as it comes from the front of the van in the loom to the rear. It also contains a 50 AMP strip fuse for the glow plugs and the solenoid for the glow plugs, aux pump relay and the round 7 pin connectors too. It's a good idea to keep the cover for this box as once its lost moisture gets in here and causes grief.If you have a turbo engine there is an auxiliary coolant pump that fires in if the engine stops and the engine is still hot (>107 deg C) and circulates coolant until the engine cools down a bit. (Syncros also have a fan blower on the turbo for extra cooling) There is also a round 7 pin connector that carries the feeds for the rear lights There is also an Earth point on the left hand side on the engine bay with about 4 Earths connected this gets crudded up and corroded its a good idea to clean it up and remake the connection or extend the earths neatly back to the neg post on the battery. This handles some important stuff like your coolant level sender so its a good idea to check it if you have unwanted engine electric behaviour. There is also a heavy duty Earth strap from the engine block to the neg battery terminal and the gearbox nose earth strap that are the path that the starter motor will take.

Browns are Earths.

The thickest (10 gauge)red goes from the alternator to the positive on the battery black live with ignition fuel cut of solenoid on the fuel pump.

feed to glow plugs from the glow plug relay is red ( 4 gauge)

white/blue temperature sender for glow plugs

brown/red feed to temperature sensor for the auxiliary pump and the high current side of the aux pump relay (inside junction box comes from glow plug relay)

red/black aux pump relay switching side (comes from glow plug relay)

a red is for auxiliary pump positive side and brown/red for the negative.

T7a = 7 pin round connector in the junction box

T7a 7 Oil pressure switch High revs yellow

T7a 6 Red white is for the auxiliary pump solenoid

T7a 5 W connector on alternator (rev counter) is green on the forward end then red white to the alt

T7a 4 earth

T7a 3 blue/green coolant shortage level sensor

T7a 2 yellow/red coolant temperature sender

T7a 1 blue/black is low pressure oil sensor low revs (note same colours used for reverse lights)

T3/1 black to D connector on alternator (charging light on dash)


T7 Round 7 pin connector that handles Lighting

T7 7

T7 6 grey/red tail light right

T7 5 grey/black tail light left

T7 4 black/blue reverse light

T7 3 black/red brake light

T7 2 black/green rear right turn signal

T7 1 black/white rear left turn signal

grey/white is fog light single connector in black box


Diesel Glowplug Wiring

Clinthefox

Diesel glow plug wiring

L white/red to indicator light

T Blue/white to temp sender

50 Red black to starter trigger

85 Brown to earth

87 Big fat red to glow plugs

30 Big fat red from fuse

86 Black from ignition

Wiring Diagramss

KY and JX diesel

Wiring Diag KY JX 00.jpg

Wiring Diag KY JX 01.jpg

Wiring Diag KY JX 02.jpg

Wiring Diag KY JX 03.jpg

Wiring Diag KY JX 04.jpg

Wiring Diag KY JX 05.jpg

Wiring Diag KY JX 06.jpg

Wiring Diag KY JX 07.jpg

Wiring Diag KY JX 08.jpg

Wiring Diag KY JX 09.jpg

Wiring Diag KY JX 10.jpg

Wiring Diag KY JX 11.jpg

Wiring Diag KY JX 12.jpg

Wiring Diag KY JX 13.jpg


CT diesel

Other