Camping Interior self build: Difference between revisions

From VW T25(T3)-Tech
Jump to navigationJump to search
← Older editNewer edit →
No edit summary
No edit summary
Line 1: Line 1:
please read [[disclaimer|disclaimer]]
please read [[disclaimer|disclaimer]]
[http://www.foamforhome.com/online_store/index.html | replacement foam]
 
[http://www.keithandsylvia.co.uk/main%20pages/technical_stuff_home_page.htm  | www.keithandsylvia.co.uk Also see]
[http://www.keithandsylvia.co.uk/main%20pages/technical_stuff_home_page.htm  | www.keithandsylvia.co.uk Also see]


Line 11: Line 11:
[[Camping Interior self build cupboards|cupboards]]
[[Camping Interior self build cupboards|cupboards]]


[http://www.vanwindows.co.uk www.vanwindows.co.uk for putting rear glass into a panel van]
[[Camping Interior self build insulation|insulation]]
 
 


'''Ian Hulley'''
Thought I'd share this company with you I had the side windows in The Bus fitted by them. Based in Castleford,they fit and guarantee 2 30" x 7" fixed roof windows for £89. Service was spot-on,friendly and sorted in about an hour and a half. No leaks since either. will only fit glass supplied by themselves based in Castleford.


Useful links
Useful links
Line 24: Line 24:




I am not sure of the fire-rating of this foam, it certainly doesn't catch fire when attacked by red-hot welding spatter, but once set alight with a match (an exposed edge for about 5 seconds) then it will burn, melt, drip and give off fumes that smell dodgy. Whether it gives off dangerous fumes, I don't know. Maybe someone could enlighten us, because it would be quite excellent, being firm yet flexible, for the roof of a van, to stop drumming, insulate and prevent condensation. To a small extent it can be formed into 3-dimensional shapes. Cut with sharp Stanley knife for accurate stripping or large carpet shears for ad-hoc trimming.
 
NB. A cheap 8mm one makes a great mat to roll-out under the van, for working on rough or wet surfaces or in sub-zero temps


----
----
'''DiscoDave'''  top tip for sticking catches on your cuboards:- works with the devon type!  push the catch to the open postition and to the to point where it gets stuck, then undo the screws at the back untill it springs forward! just as it should!

Revision as of 10:27, 3 March 2006

please read disclaimer

| www.keithandsylvia.co.uk Also see

beds

installing windows

flooring

cupboards

insulation



Useful links Insulating and rust profing a Bay Applies equally to T25 in principle and improving the air-cooled heater section is excellent (Ubiquitous Bulley-Hewlett write-up)

Rust proofing and insulating the seat boxes (club80-90 Wiki)



Retrieved from "https://club8090.co.uk/w/index.php?title=Camping_Interior_self_build&oldid=2801"