|
|
| (21 intermediate revisions by 5 users not shown) |
| Line 1: |
Line 1: |
| | '''Also See''' |
| | |
| please read [[disclaimer|disclaimer]] | | please read [[disclaimer|disclaimer]] |
|
| |
|
| [http://www.keithandsylvia.co.uk/main%20pages/technical_stuff_home_page.htm | Also see1] | | [[Camping Interior self build from scratch|Scratch-build interior]] |
| | |
| | [[Camping Interior self build DIY conversion DVLA\insurance|DIY conversion DVLA/Insurance]] |
|
| |
|
| [http://www.vanwindows.co.uk www.vanwindows.co.uk for putting rear glass into a panel van] | | [[Camping Interior self build beds|Beds]] |
| '''Ian Hulley'''
| |
| Thought I'd share this company with you I had the side windows in The Bus fitted by them. Based in Castleford,they fit and guarantee 2 30" x 7" fixed roof windows for £89. Service was spot-on,friendly and sorted in about an hour and a half. No leaks since either. will only fit glass supplied by themselves based in Castleford.
| |
|
| |
|
| Useful links
| | [[Camping Interior self build windows|Installing windows]] |
| [http://www.type2.com/library/heat/heat-soundproof.html Insulating and rust profing a Bay] Applies equally to T25 in principle and improving the air-cooled heater section is excellent (Ubiquitous Bulley-Hewlett write-up) | |
|
| |
|
| [[Bodywork and Glass Insulation|Rust proofing and insulating the seat boxes (club80-90 Wiki)]] | | [[Camping Interior self build flooring|Flooring]] |
|
| |
|
| ----
| | [[Camping Interior self build cupboards|Cupboards]] |
|
| |
|
| '''HarryMann''' If you require to fill the pressed 'fingers' in the floor of the T25, then consider this:-
| | [[Camping Interior self build insulation|Insulation]] |
| To damp sound or insulate before laying your chosen floor (ply, rubber mat or carpet) then consider camping sleep mats.
| |
| Those pressings are 10mm deep. Closed cell (cross-linked) roll-up camping sleep mats come in 6, 7, 8 and 10mm (12mm with foil face sometimes, the super-duper ones). They are stable and waterproof.
| |
| Using a heavy-duty spray adhesive, spray an even single coat on both surfaces, after having accurately cut the roll into strips using a Stanley knife and straight-edge on a soft but flat surface (your largest carpeted room is ideal, if you've been a carpet fitter in a previous incarnation, you'll know what I mean!), leave for 1 minute in hot or 2 or 3 in cold weather, then they tack down just perfect. You then have an easy way of filling the bulk of that gap. The 10mm mats tend to be twice the price of the 8mm ones (£9-99 rather than £4-99, but you should only need one). Don't buy yoga mats, they're fancy and being sporty, ''designer'' and over-priced! eBay usually have many different types, but they '''have''' to be 10mm thick.
| |
| The pressed fingers are different widths, they tend to be 1 3/4"; 2 1/4" and 2 1/2"... the flat part, I didn't try to sculpt the foam into a perfect chamfered cross-section, but it ''is'' quite possible to chamfer it, using a brand-new floorer's hand-scraper blade (quite lethal things, just don't slip).
| |
|
| |
|
| [[Image:Clive-Filling-the-fingers.jpg]] | | [[Camping Interior self build roofs|Roofs]] |
|
| |
|
| I am not sure of the fire-rating of this foam, it certainly doesn't catch fire when attacked by red-hot welding spatter, but once set alight with a match (an exposed edge for about 5 seconds) then it will burn, melt, drip and give off fumes that smell dodgy. Whether it gives off dangerous fumes, I don't know. Maybe someone could enlighten us, because it would be quite excellent, being firm yet flexible, for the roof of a van, to stop drumming, insulate and prevent condensation. To a small extent it can be formed into 3-dimensional shapes. Cut with sharp Stanley knife for accurate stripping or large carpet shears for ad-hoc trimming.
| | [[Camping Interior self build carpets|Carpets]] |
| NB. A cheap 8mm one makes a great mat to roll-out under the van, for working on rough or wet surfaces or in sub-zero temps
| |
|
| |
|
| ----
| | [[Camping Interior self build water|Water]] |
|
| |
|
| | [[camping Interior self build The Devon Box|The Devon Box]] |
|
| |
|
| '''DiscoDave''' top tip for sticking catches on your cuboards:- works with the devon type! push the catch to the open postition and to the to point where it gets stuck, then undo the screws at the back untill it springs forward! just as it should!
| | [[camping Interior self build Reimo technical drawings for interior cupboards and beds|Reimo technical drawings for interior cupboards and beds]] |
