Castle Nut
Moderators: User administrators, Moderators
- jammcd649
- Registered user
- Posts: 49
- Joined: 16 Aug 2006, 21:35
- 80-90 Mem No: 2842
- Location: Nr. Bridgnorth Shropshire
Castle Nut
Just checking, what size is the castle nut on the rear hub???? 46mm???
1986 1.9 Watercooled Camper - Diamond RV
- toomanytoys
- Trader
- Posts: 2870
- Joined: 11 Oct 2005, 18:37
- 80-90 Mem No: 41
- Location: Boston area, South Lincolnshire
bigherb wrote................
Steady on, three fat blokes perhaps but...... 500 NM is only 369 lbs/ft.
Which is only 184.5 lbs on the end of a two foot pole,
or 92.25 lbs at the end of a four foot pole,
and even I can tip the scales over 92 lbs.
Nut with ten slots is 500 Nm= 678 ftlbs = Three fat blokes
Steady on, three fat blokes perhaps but...... 500 NM is only 369 lbs/ft.

Which is only 184.5 lbs on the end of a two foot pole,
or 92.25 lbs at the end of a four foot pole,
and even I can tip the scales over 92 lbs.

'Two 'eads is better'n wun even if mine's a sheeps'
Grun
Member Number 1250
D reg 2.1 DJ autosleeper poptop
Grun
Member Number 1250
D reg 2.1 DJ autosleeper poptop
Re: Castle Nut
kev,
I could pose for the ' before ' in the Charles Atlas advert,
always did get the sand kicked in my face,
and ( Fortunately) never got the girl. 
Currently, 11 stone... 154lbs ...70 kgs... fully clothed, soaking wet.
Tighten 'till it strips the thread and then back off to the nearest split pin hole we used to (jokingly) say!!
Mike
I could pose for the ' before ' in the Charles Atlas advert,



Currently, 11 stone... 154lbs ...70 kgs... fully clothed, soaking wet.
Tighten 'till it strips the thread and then back off to the nearest split pin hole we used to (jokingly) say!!
Mike
'Two 'eads is better'n wun even if mine's a sheeps'
Grun
Member Number 1250
D reg 2.1 DJ autosleeper poptop
Grun
Member Number 1250
D reg 2.1 DJ autosleeper poptop
Re-Castle nuts
Do the rear castle nuts undo normaly or is the N/S a left hand thread? I will have to take mine into a garage where they do wagon tires, and get them to get this off by air, as i have broken 3 T bars?