Sliding door trim

[FarWare12]

What does the trim/threshold on your sliding door look like? I just put a new floor in and am a bit stuck for ideas on how to trim the end near the sliding door. I know there are several pre-made options available but I find them a bit expensive, except if I opted for the plastic version, which probably won't be very durable.

 

[lefty67]

Mines is made from black angled plastic. Never broken etc in the 9yrs I've had the van.
It has two angled joints which are fused/melted together.

[Mocki]

Try speaking to Mick Crowe ucp.php?i=pm&mode=compose&u=24011 he may have one

[FarWare12]

Mines is made from black angled plastic. Never broken etc in the 9yrs I've had the van.
It has two angled joints which are fused/melted together.

Did you buy it or make it?

[FarWare12]

Try speaking to Mick Crowe ucp.php?i=pm&mode=compose&u=24011 he may have one

I'm not in the UK so that might be difficult/too expensive unfortunately

[Mocki]

May i suggest you fill in the profile info , if you give this information you would get better help

[lefty67]

Mines is made from black angled plastic. Never broken etc in the 9yrs I've had the van.
It has two angled joints which are fused/melted together.

Did you buy it or make it?

I didn't make it. It was on the van when I bought it. It is homemade though and isn't hard to do
I'll post a couple of pics up when I get my van back from the garage