The basics: remove alternator, remove the four screws that hold the casing halves together, rotate rear housing and windings *as one* by 90 degrees, replace screws.
Charging cable and warning lamp terminals are still easily accessible.
"clocking" your wbx alternator mod
Moderators: User administrators, Moderators
-
silverbullet
- Trader
- Posts: 16349
- Joined: 08 Jun 2009, 09:51
- 80-90 Mem No: 6908
- Location: Surrey Syncronaut #156
- Contact:
"clocking" your wbx alternator mod
I had to do this due to a foul on my wbx6 between one regulator mounting screw and the inlet manifold (which could have then cracked the plastic) the benefit being that you can change the brush pack without removing the alternator. Might be of use to other wbx owners?
The basics: remove alternator, remove the four screws that hold the casing halves together, rotate rear housing and windings *as one* by 90 degrees, replace screws.
Charging cable and warning lamp terminals are still easily accessible.
The basics: remove alternator, remove the four screws that hold the casing halves together, rotate rear housing and windings *as one* by 90 degrees, replace screws.
Charging cable and warning lamp terminals are still easily accessible.