Issue Starting

Big lumps of metals and spanners. Including servicing and fluids.

Moderators: User administrators, Moderators

Post Reply
herman_t25
Registered user
Posts: 38
Joined: 13 Jun 2022, 08:55
80-90 Mem No: 0

Issue Starting

Post by herman_t25 »

Morning All,

recently got our T25 got a few issues to sort. One immediate one I'm having is he struggles to start at times.

At the weekend it struggled a few times to get going (though it was just cold) so didn't pay much attention. Next morning it wouldn't go at all. finally managed to start it after towing it across my field. Swapped the battery for a working one out of my golf and started fine. 

took out again last night and the same issue again. started first time went for a drive then when I got home turned it off and tried to start again and nothing. (still using the newer battery)

Its trying to start but doesn't seem to want to fire. what's anyone's thoughts about where to start.

hopefully ruled out a bad battery by using two different ones. 

I'm thinking either Alternator? starter motor maybe?

cheers

davidoft1
Trader
Posts: 2593
Joined: 27 May 2009, 18:56
80-90 Mem No: 16628
Location: hayling island

Re: Issue Starting

Post by davidoft1 »

how are you trying to start it, you need to depress the throttle pedal once to engage the choke 

cobblers
Registered user
Posts: 587
Joined: 21 Feb 2010, 20:50
80-90 Mem No: 17450
Location: Derbyshire

Re: Issue Starting

Post by cobblers »

If it's turning over then the fault isn't the alternator or the starter motor.

herman_t25
Registered user
Posts: 38
Joined: 13 Jun 2022, 08:55
80-90 Mem No: 0

Re: Issue Starting

Post by herman_t25 »

davidoft1 wrote: 21 Jun 2022, 10:00 how are you trying to start it, you need to depress the throttle pedal once to engage the choke 

not this way! turning it over and giving it a bit of throttle. this could be why it works sometimes and others it doesn't! if that's what it was i'll kick myself  :lol: :roll:  do you depress to engage and release or leave it depressed ?

User avatar
jrt
Registered user
Posts: 3418
Joined: 01 Oct 2011, 15:53
80-90 Mem No: 10288
Location: East Cheshire

Re: Issue Starting

Post by jrt »

Take the pipe off the pump outlet into a jar and see what the fuel delivery is like.
Take of the pump and measure the pump push rod( should be 100mm) and grease underneath it.
Fuel filter clean/ gauze filter clean int the cab’ inlet.
Will it fire up with a bit of fuel down the top of the car?
I’m assuming it’s a petrol with manual pump.
David.
the future is unwritten

TONYT25T25
Registered user
Posts: 1830
Joined: 16 Sep 2013, 17:19
80-90 Mem No: 13596
Location: Hampshire

Re: Issue Starting

Post by TONYT25T25 »

As above, when starting from cold, depress accelerator pedal slowly, then release it, start engine, do not use accelerator. Starting a warm or hot engine, depress accelerator pedal slowly and hold in full throttle position, do not pump the pedal, release pedal as soon as engine starts. This is procedure for manual petrol.
1984 Campervan 1.9DG Petrol WBX

davidoft1
Trader
Posts: 2593
Joined: 27 May 2009, 18:56
80-90 Mem No: 16628
Location: hayling island

Re: Issue Starting

Post by davidoft1 »

herman_t25 wrote: 21 Jun 2022, 11:25
davidoft1 wrote: 21 Jun 2022, 10:00 how are you trying to start it, you need to depress the throttle pedal once to engage the choke 

not this way! turning it over and giving it a bit of throttle. this could be why it works sometimes and others it doesn't! if that's what it was i'll kick myself  :lol: :roll:  do you depress to engage and release or leave it depressed ?

Press and release

herman_t25
Registered user
Posts: 38
Joined: 13 Jun 2022, 08:55
80-90 Mem No: 0

Re: Issue Starting

Post by herman_t25 »

davidoft1 wrote: 21 Jun 2022, 13:19
herman_t25 wrote: 21 Jun 2022, 11:25
davidoft1 wrote: 21 Jun 2022, 10:00 how are you trying to start it, you need to depress the throttle pedal once to engage the choke 

not this way! turning it over and giving it a bit of throttle. this could be why it works sometimes and others it doesn't! if that's what it was i'll kick myself  :lol: :roll:  do you depress to engage and release or leave it depressed ?

Press and release
Tried this last night and worked perfect! thanks
 

davidoft1
Trader
Posts: 2593
Joined: 27 May 2009, 18:56
80-90 Mem No: 16628
Location: hayling island

Re: Issue Starting

Post by davidoft1 »

herman_t25 wrote: 22 Jun 2022, 13:24
davidoft1 wrote: 21 Jun 2022, 13:19
herman_t25 wrote: 21 Jun 2022, 11:25

not this way! turning it over and giving it a bit of throttle. this could be why it works sometimes and others it doesn't! if that's what it was i'll kick myself  :lol: :roll:  do you depress to engage and release or leave it depressed ?

Press and release
Tried this last night and worked perfect! thanks
 

Easy fix :D

herman_t25
Registered user
Posts: 38
Joined: 13 Jun 2022, 08:55
80-90 Mem No: 0

Re: Issue Starting

Post by herman_t25 »

davidoft1 wrote: 22 Jun 2022, 17:46
herman_t25 wrote: 22 Jun 2022, 13:24
davidoft1 wrote: 21 Jun 2022, 13:19

Press and release
Tried this last night and worked perfect! thanks


Easy fix :D
happy to feel a bit stupid but save some money  :lol:
 

Post Reply