So long story short inherited someone else’s bodge of a conversion. Slowly righting the many wrongs. Now I’m looking at the exhaust.
Its current abomination is a mix of "pooh" welds, three silencers, hangers all over the place and one bolt holding the wonky back box which is so low it scrapes everything.
Now if I’m reading correctly, there is one exhaust manifold that I can use a normal diesel exhaust on, otherwise it’s a custom jobby.
Below is a picture (kind of) of my current set up. Is this by any chance the correct one so I can just buy an off the shelf system?
If not, which manifold do I need to buy, and what exhaust to fit to it?
Hope that makes sense?
Sent from my iPhone using Tapatalk