Hi All,
Any one any experience of removing the three studs from the inlet manifold on a 1.9 DG water cooled engine?
They seem incredibly tight and the 2 nut way with loads of WD40 has done 0!
Manifold studs
Moderators: User administrators, Moderators
Re: Manifold studs
Heat and molegrips clamped about an inch from manifold.
MaxStu
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
1987 DG1.9 LPG Auto Autosleeper
"Blissfully happy in your presence".
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
1987 DG1.9 LPG Auto Autosleeper
"Blissfully happy in your presence".
-
- Registered user
- Posts: 148
- Joined: 16 May 2018, 08:12
- 80-90 Mem No: 0
- Location: Cycle City on the Cam
Re: Manifold studs
Do you mean 1 inch from manifold to bottom of jaw anyhow much heat?
Should I concentrate the heat to the stud or manifold?
Thanks in advance
Should I concentrate the heat to the stud or manifold?
Thanks in advance
-
- Trader
- Posts: 16342
- Joined: 08 Jun 2009, 09:51
- 80-90 Mem No: 6908
- Location: Surrey Syncronaut #156
- Contact:
Re: Manifold studs
They are fixed with loctite. Heat the manifold off the engine with a propane lamp and remove the central cold start hedgehog heater first!
Re: Manifold studs
As SB says...direct heat at the manifold around base of stud. How much? Moving about torch for 30 seconds to a minute should do it. Jaws about one inch above manifold to minimise twist.
Impact driver for hedgehog screws. And a bit more heat!
MaxStu
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
1987 DG1.9 LPG Auto Autosleeper
"Blissfully happy in your presence".
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
1987 DG1.9 LPG Auto Autosleeper
"Blissfully happy in your presence".
-
- Registered user
- Posts: 148
- Joined: 16 May 2018, 08:12
- 80-90 Mem No: 0
- Location: Cycle City on the Cam
Re: Manifold studs
Thanks for the advice I have been soaking them for two days now and putting the molegrips as recommended I have just moved one stud about half way out I think. So I'll carry on with this method penetrating oil and muscle power (except I don't have much) but I guess that may stop them breaking off with a little luck!
-
- Registered user
- Posts: 148
- Joined: 16 May 2018, 08:12
- 80-90 Mem No: 0
- Location: Cycle City on the Cam
Re: Manifold studs
Two out one to go but the last one seems extremely well in there!
Re: Manifold studs
Heat!. Even a hair drier ser at max will help.
I use a hot air gun/paint stripper.
I use a hot air gun/paint stripper.
MaxStu
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
1987 DG1.9 LPG Auto Autosleeper
"Blissfully happy in your presence".
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
1987 DG1.9 LPG Auto Autosleeper
"Blissfully happy in your presence".