What’s the best system when fitting new side panels with regard to the seams. I was thinking bare metal, etch primer , plug weld, inject seams with rust preventer (RC2000), then seam sealer and finally filler on the external seam
What’s the best way of applying seam sealer and in what size gap?
Thanks
Seams
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 38
- Joined: 16 Oct 2005, 13:00
- 80-90 Mem No: 1838
- Location: newquay,cornwall
Seams
glennyboy2
member 1838
Caroline,86 Leisuredrive Hitop, 1Y diesel
member 1838
Caroline,86 Leisuredrive Hitop, 1Y diesel
-
- Registered user
- Posts: 68
- Joined: 29 Apr 2018, 19:16
- 80-90 Mem No: 16836
- Location: West Midlands
Re: Seams
i did the following.
- cleaned metal with preparation wheel.
- cleaned bare metal with panel wipe
- applied weld through primer (upol copper)
- plug welded
i still need to epoxy and seam seal
- cleaned metal with preparation wheel.
- cleaned bare metal with panel wipe
- applied weld through primer (upol copper)
- plug welded
i still need to epoxy and seam seal