Starter Motor wiring

[PhilNorwich]

Hi All, my first post on here, I used to have T2s but now have a T25
My van won't start, it won't turn over, i've changed the starter motor, relay, ignition switch and even tried a different battery, i've tracked it down to starter not getting 12v when i ran a continuity cable, my question is how do i ran a new cable from fusebox the starter, where exactly on the fusebox do i need to change?

TIA

Phil

[937carrera]

Start off by reading the wiring diagram available from http://syncrosport.com/info/wiring/

When you have done that you will discover that there is no fuse on the starter cable

Checks to do:

Battery fully charged (sorry) ?
Continuity from battery +ve to starter terminal ?
What voltage at the starter teminal ?
Earth straps in good condition ?
Remove the solenoid wire, 12v when the ignition switch is put into the run position ?

[Mocki]

It would help if you added the details of your vehicle to your profile or signature 

there is no fuse, or relay , the starter has a solenoid which is a relay . 

[robertneill602]

A Haynes Manual will help. On the wiring diagram there maybe single point joints marked with a T suffix. These maybe be behind the fusebox and kick panels in the cab/around under dashboard area. Would also check the wiring loom condition around floor entry and underside of van. I don't know if there are further points such as the steering column and underdash body seems on where the wiring loom can rub against.