keynsham1 wrote:I have a Renault Scenic which has a roof mounted rear middle seat belt. It is pulled over the shoulder and then clips on both sides to give the three point support. The back of my Hi-top has the existing production roof beam running across the top of the rear hatch. If I was to put a reinforcing strip inside the box section and bolt the Renault type roof mounted belt there, my problems would be solved! This is assuming I can arrange suitable buckles to accept the belts which I am sure I can. The belt is almost 10 feet long fully extended so is plenty long enough.
Has this been considered before?
this is exactly what I did, check link in post above!!
Although I didn't use scenic belts as one tongue is specific for the receiver, so not universal with other receivers. not a problem if you get the receiver also but when I looked at this I thing I had mounting issues.
the best vehicle is VW touran or a ford galaxy. the galaxy actually used a VW part so they are the same!!
I picked mine up from a local dismantlers who have the history of all vehicles, so I choose two vehicles that were engine damaged/water etc so I knew the belt had not been involved in a collision.
