Urgent help fitting new window rubbers

[maxstu]

Please help with tips and techniques to refit side window with new rubbers.

So far in WIKI the advice is pay someone else to do it.

But Im in Congleton and need to drive to London tomorrow so intend to do the task myself

Regards
Stuart 07961 423324

[Plasticman]

would this be aftermarket windows or factory fit (ie have the rubbers got a filler bit to fit in the middle)
mike

[maxstu]

aftermarket pls

[dbz864]

not to difficult.Fit the rubbers to the van,spray them with some soapy water(and keep spraying them).Place the window in the rubber(bot first)then flip/force the rubber around the glass,with a plastic spatula,or similar(not a screwdriver or anything else metal).

[Plasticman]

Then you need the tool to insert the locking strip into the rubber
mike (see wiki)

[maxstu]

yes. Thats the method lve tried without success. Trying to keep rubber in cut out is a big prob. Am using tape and glue to hold it

[Plasticman]

Ok .look assuming you have the correct rubber? then remove al the soap etc, and dry them, next dry off the aperature, fit the rubber in the hole so that the join is at the top, use something like 2" masking tape on the inside to help keep it in place, though with pliable new rubber shouldnt need to , anyhow with rubber in hole get a small brush ie paintbrush and if you have no rubber lube then brush a slight ammount of fairy into the groove the glass sits in, then as said glass into bottom and if you dont have the tool (looks like a small 3/16" ball on the end of a screwdriver then a bit of plastic a teaspoon handle anything like that that isnt sharp and use one forearm to keep the glass in and t'other hand to work the seal over the glass, Im rht handed so start doing the bottom then work up rht side to top(but not the corner itself, then same on left side then do top corners and in, then you will need to fit the expansion/locking strip. pig without the tool though, whip the van down to an auto glass place if you are really desperate.
mike

[maxstu]

cheers. Two done so far

[maxstu]

still working on it but getting there

[maxstu]

Hi MM,

Thanks so much for your advice last year when trying to fit new window seals to my coverted transporter.

I managed in the end to fit all rubbers as you suggested but have subsequently found out that Schofields sent me the wrong seals. The glass and metal recessess were the same width, about 4mm.

My understanding is the seal to glass ressess is 4mm but for the bodywork the gap should only be about 1.5mm. Hence the reason when attempting to fit seals they kept collapsing inwards.

Do you supply or can you recommend a supplier who will send the correct sizes?

Thanks again
Stuart

[Plasticman]

hi , well that explains a lot ,I feel for you tryingto fit those, yes I have the correct seals in stock , will pm you in a minute ( when coffee is made) lol
mm