I am in search of a 'key' to remove the wheel nut cover plate from my alloys.
The cover plate has a 'WSL' logo and has a security bolt holding it on.
The bolt looks like a Torx head with a centre pip. A T55 Torx driver comes close but doesent have the hollow centre.
Any ideas?
T
Alloy key
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 70
- Joined: 02 Nov 2005, 20:28
- 80-90 Mem No: 2314
- Location: chesterfield member number 2314
centre cap
you need a "tamper proof torx bit" try machine mart and halfords but you might have to buy a set with a few in hope this helps
- tonytech
- Registered user
- Posts: 1194
- Joined: 11 Oct 2005, 06:40
- 80-90 Mem No: 477
- Location: Liverpool
I've sorted this now.
The origional key was plastic and had been well rounded.
I managed to get one bolt out, heated it up and forced it onto the key. cutting new ridges.
I'd still like a metal version if possible but I've not seen any security torx bigger than T50.
T
The origional key was plastic and had been well rounded.
I managed to get one bolt out, heated it up and forced it onto the key. cutting new ridges.
I'd still like a metal version if possible but I've not seen any security torx bigger than T50.
T
There are 10 kinds of people. those who understand Binary and those who dont