servo hose? Sorted thanks!
Posted: 16 Feb 2011, 17:20
Another silly question no doubt, but here goes
Right, the pipe work on this was reet brittle and snapped
I presume that this is the servo hose(?)
The hose seems to be heat crimped or something ::shrug:: onto the non return valve.... assuming the valve is fine am I alright to use a bit of fuel hose of the appropriate girth and jubilee clips to attached the valve back up to the carb balancing pipe? (thats the bit where it snapped)..... or is that foolish? i.e Rather than sourcing the hard plastic tubing, and getting it sealed onto the valve unit.
Thanks in advance (again)
Billy
Right, the pipe work on this was reet brittle and snapped
I presume that this is the servo hose(?)
The hose seems to be heat crimped or something ::shrug:: onto the non return valve.... assuming the valve is fine am I alright to use a bit of fuel hose of the appropriate girth and jubilee clips to attached the valve back up to the carb balancing pipe? (thats the bit where it snapped)..... or is that foolish? i.e Rather than sourcing the hard plastic tubing, and getting it sealed onto the valve unit.
Thanks in advance (again)
Billy