Autosleeper fridge relay q

[baj25]

I’ll soon be fitting a leisure battery to my van (1990 Autosleeper). Van has fridge in already, and has a relay connected into ignition so fridge is only on 12v when engine running. Does anyone know if AS use the ignition warning light circuit to switch the relay or just the ignition switched supply? I have the wiring diagram from wiki, which says ignition switch but I have doubts about that. Also, where is the fridge relay, so I can connect coil of my split charge relay to it? (assuming it is from ignition light not switch). Ta, Bri

[Shaundon]

fridge relay is on top of the fridge (assuming rm184 in a club joker like mine) see this link

http://forum.club8090.co.uk/viewtopic.p ... g#p7970385

can be seen as the grey box near the bottom right of the picture of top of fridge

although not sure whats the setup in an auto sleeper

[baj25]

Half answered my own question with some digging around last night. With original AS wiring, fridge can be powered from 12V when the ignition is on (engine doesn't need to be running), therefore note on wiring diagram on wiki is spot on. So I gave up trying to find the relay as it is bog all use to me for split charging. Cheers, Bri

[kevtherev]

the relay is behind the control panel..(wired into it)
Maplin sell 50 amp relays for a few quid

[baj25]

Cheers Kev, had the zig out to see what was going on behind there, and found the relay behind it as you said. ta, Bri