Club 80-90 Forums

I have a set of 16" drums that i'm cleaning up, before i spend too much time on them is there a maximum dimension or wear limit?
They have a very slight lip on them, maybe 1mm..
So if someone has the new vs max worn dimensions i'd be a happy man
thank yoo

Bet it says it on them...

Alright, alright. had no idea it would be written on them.
Max diameter 10.69"

That's the one.. I would grind the lip off using a angle grinder and a flap disc...just the lip..don't you into the shiney bit..makes it possible to whip the drums off to clean without having to wind the adjuster back each time.

so go on... are they within spec?

Well, my d*#k won't fit in so its definitely less than 10.8"..

But that's longer than your legs Lloyd.

I am confused, are you asking about diameter or thickness?

For new discs the thickness is 16mm and the wear limit 13-14mm

Simon Baxter wrote:But that's longer than your legs Lloyd.

It's a cross I have to bear....

lsidir wrote:I am confused, are you asking about diameter or thickness?

For new discs the thickness is 16mm and the wear limit 13-14mm

This is for the rear drums

ooopsss sorry:)

did not had enough coffee yet!

out of spec, measure up dead on the wear limit. They are coming up nice and clean though, pics on me build thread

I would use them at that...it is also possible to get shoes relined by brake specialists with over sized friction material....obviously there is a point where safety becomes a factor but its possible..