Big Blue Van - Full Restoration

For documenting and technical details of T25 restorations and major repairs
This section is for major restorations only.where to buy a panel or where to buy window rubbers belong in the bodywork seats and glass section.
Also please note,we need pictures of the restorations,without them posts are pretty useless.[\b]
Picture heavy and detailed threads , not for general banter or advertising
Traders welcome to post but not to advertise blatently
Threads will be cleaned of chit chat.

Moderators: User administrators, Moderators

Post Reply
User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Starting on the offside!

The time has come to work on the offside of the vehicle for a while.

A reminder of what it looked like...
Image

An evening worth of chopping and cutting has left me with this.
Image
Image


The inner c pillar had rotted out where the holes for the door catch would be on a Nearside or twin slider model, so this rot has been cutout.
Image

Being as it has no sliding door there is no need for me to make an exact copy with the formed section for the sliding rail track I'll just patch it all up and refit the cover plate, you'll never know 👍

Continue cutting stuff out tomorrow and need to strip all the rubber underseal from the arch too, such a faff!!!

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Test fit the offside inner arch

This evening was spent removing the old inner arch on the offside and test fitting the new one,, same as the other side this panel just chopped down to allow the rear quarter panel to sit on it.

Image
Image

Surprised how easy the old arch came off, having already done the other side definitely helped as I knew what not to do this time to speed it up!

Also found some crusty rubbish on the outer d pillar where the faux sliding rail cover butts up. So got that small section chopped out.

Image

Some more surface prep will be next along with removing all the underseal within the arch area.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Offside inner C pillar repair

Spent today on the inner C pillar.
Made up a patch peice which had a small tapered step and was also curved so the shrinker/stretcher was put to use.

Image
Image
Image

Also did a trial fit of the centre panel and rear quarter.
Image

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Some more test fitting

Spent time today chopping bits about and test fitting panels.

Got the front arch test fitted and all the side panels installed and aligned with just cleco pins for now.

Image

Made a new section for under the sliding rail cover out of some steel recycled from the good section of the old side panel.

Image

The B pillar will be rebuilt next.

Schnippzle
Registered user
Posts: 715
Joined: 28 Nov 2020, 16:36
80-90 Mem No: 17435

Re: Big Blue Van - Full Restoration

Post by Schnippzle »

An immense amount of fantastic work. 
1988 Caravelle - FB25B - Syncro converted
2016 MB E63 AMG S - The daily driver
2019 Harley Fat Bob - The leisure
ZsZ wrote: WOW! thats seems simply not right.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Making the offside lower side panel

Many moons ago I purchased a side panel repair peice which includes the portion for connection to the inner sill.

Since then however I hacked out the rest of the side panel and bought a full repair peice. This however does not include the lower portion..
So I spent this evening converting the original panel to be more suitable for use rather than having to buy yet another panel..

Here's the gap we need to close up...

Image

The panel I had as It was...

Image

Chopped down, flanges created and a lip being tipped over...

Image

The finished article after modification...

Image

Test fit happy with the initial fit, some finer fettling will be required before welding in for good...

Image
Image

Another shift done.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Rebuilding the offside B pillar

Started to rebuild the B pillar, started with painting the pillar internally as much as I could.
Then made a repair panel for the front arch side of the pillar.

Image

Welded it all up.

Image
Image

Done for today.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Finishing the offside B pillar

Completed the offside B pillar today,
Some small infills were needed near the bottom, also a closing panel was installed for the wheel arch side. Before knocking the welds back.

Image
ImageImage

I would like to get some epoxy primer on it but will wait until I have cleaned most of the other surfaces on this side of the van.
Will try and get on with that as the next main task.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Prepping the offside for epoxy primer

Today was spent removing paint, rust and crud from the offside.
Took all day and made quite the mess and a good dent into the sanding consumables.

Once all stripped the surfaces were degreased and then a coating of phosphoric acid applied.

Image
Image
Image

Hope to get some epoxy primer down on it all tomorrow evening after work.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Epoxy primer on the offside

Got the epoxy primer down this evening,, always amazes me the amount of effort required to get to a point where you paint a massive area in 30mins!!! If only the prep was that quick.

Image
Image
Image

Can start thinking about rebuilding the panels on this side now.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Starting to rebuild the offside

Spent this evening doing a repair to a cross member in the engine bay.

Image
Image
Image

Then moved onto the repair section which is tapered and sits behind the rear valance, the tapered section is what the battery tray panel butts up to.

Image
Image
Image
Image

The rear valance repair section will be next.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Offside rear valance and inner D pillar rebuilding

Another good shift today,
Started with repairing a small section of the rear valance.

Image
Image

Then extended the inner D pillar support which connects to the battery tray.

Image

Then made up the rear valance corner repair section, welded in, dressed back and primed.

Image
Image

Ended the day with making up the panels which support the outer D pillar lower panel and the rear edge of the quarter panel.
Used the bead roller to stiffen the panels up and stepped a lip where it interfaces with the battery tray.
An awkward tapered bend is required to get everything lined up nicely.

Image
Image
Image
Image

These panels need a little more trimming, need to refit the inner arch and quarter to make sure everything is aligned before trimming to the final size.

RogerT
Registered user
Posts: 1798
Joined: 10 May 2013, 11:59
80-90 Mem No: 13706
Location: Central Scotland

Re: Big Blue Van - Full Restoration

Post by RogerT »

Jesus, you make it look so easy, and clean, and just so bleeding PERFECT! AAARRRGGGHHH!

Hats off. You are the Don.
Have you ever seen an unhappy fool?

88 Transporter with hitop camper conversion, 1.6td.

User avatar
BigBlueVan
Registered user
Posts: 137
Joined: 21 Dec 2020, 20:45
80-90 Mem No: 0

Re: Big Blue Van - Full Restoration

Post by BigBlueVan »

Offside panel fitting

A few good shifts has got some of the panels fitted to the offside of the vehicle.

Got all the little bits on the inner panels done and painted.

Image

Installed the rear lower D pillar.

Image

Installed the faux sliding rail area which lives under the clip-on cover.

Image

Installed the rear quarter, cleaned the welds back and popped some etch primer on to protect.

Image
Image

I made up a new top section for the side panel, I'll trim it down to suit for the window at a later date.

Image

Then refitted the side panel with the good old cleco pins.
All coming together nicely.

Image

Have some tweaks to make to the side panel and an infill plate, so that will be next on the list.

colinthefox
Registered user
Posts: 857
Joined: 20 Oct 2009, 18:42
80-90 Mem No: 16447
Location: Somerset
Contact:

Re: Big Blue Van - Full Restoration

Post by colinthefox »

RogerT wrote: 14 Nov 2021, 22:35 Jesus, you make it look so easy, and clean, and just so bleeding PERFECT! AAARRRGGGHHH!

Hats off. You are the Don.
I'll second that. How nice to see a clean, tidy, safe, well lit working environment. It's half the battle, and gives us all encouragement. Keep it up! Where's all your stuff? Is your dining room full of the van interior?
 
1.9D (AEF) pop-top. Aaaaahhhhh........that's better.
Image

Post Reply