Re: (Not so sweet) Caroline
Posted: 19 Sep 2020, 13:50
Brilliant! That’s just what I was looking for. I see it does go through that slot.
And the front repair is exactly the same as I need to do, that really helps. Can’t get a reference point for the sill until it’s got something firm to fix to.
I’ll be honest, I really am crap at getting straight cuts on any thing. I think it’s because I’ve been using really thin discs, I can see them bending sometimes while I’m cutting. I’ve got a cut off tool now , so might use that where I can.Bit scared about cutting the centre panel in. It’s a good panel and goes right the way up. Might even joddle it in then weld it.
Ive temporarily put the new swing arm on so I can see where it all goes.
And the front repair is exactly the same as I need to do, that really helps. Can’t get a reference point for the sill until it’s got something firm to fix to.
I’ll be honest, I really am crap at getting straight cuts on any thing. I think it’s because I’ve been using really thin discs, I can see them bending sometimes while I’m cutting. I’ve got a cut off tool now , so might use that where I can.Bit scared about cutting the centre panel in. It’s a good panel and goes right the way up. Might even joddle it in then weld it.
Ive temporarily put the new swing arm on so I can see where it all goes.