hot to remove rear bulb connector?

[Shinnster]

hey all,
may be a stupid question but how do you get the connector out of the rear bulb holder? ive pulled at it with quite a bit of force and its not moving.
is there a tab of some sort to push in to remove it? i couldn't see one anywhere and didnt want to keep yanking at the wires in-case of ripping them out wrong

 

[TONYT25T25]

I guess you are talking about separating the cluster to get access to the lamps, there is a tab at the end which needs to be pulled inwards, but be careful not to break it.

[Shinnster]

sorry, should have taken a pic when i had it off.
i got the parts separated, but trying to remove the cables out of the holder and yanking on them doesnt seem to do anything

trying to replace my ulo bulb holder with a hella one

[Jim San]

Once you've peeled back the rubber boot, the connector should wiggle out easily

[syncroandy]

As said, the rubber boot should be pulled back, carefully as they tend to get quite fragile and tear easily. The plug can be quite firmly attached, so to avoid undue strain on the wires, I'd suggest using a flat blade screwdriver to carefully pry the plug a couple of mm at each end to loosen it.

[Shinnster]

tried a few times now to remove these connectors, using a screwdriver to try and pry it up.... nothing.
pliers and yanked as hard as i could.... still nothing.
would they be corroded that bad to not budge at all? tried both sides and no movement at all

[TONYT25T25]

Try posting a couple of images of the area in question it may prompt a few more suggestions.

[Shinnster]

i'll add a pic tomorrow, but its literally the wire cable connector that goes into the holder

[Stesaw]

When I tried to remove mine the plastic connector was stuck as well. Don't try and rag it out by the wires .
To get mine off I did what andy said, use a small flat screwdriver on each edge to try and brake the seal and gently pry it out from the ends. 

[Shinnster]

this is what I cant get out. tried slowly prying out, tried brute force. is not budging at all.
its like theres a tab somewhere I should be disengaging or something.

[TONYT25T25]

I see what you mean, are the wires removable with I would guess with their bayonet or similar clips, if these were removed (obviously noting the orientation in the holder}, would this release pressure on the other side and give you a better purchase on the holder itself. IE the unit could then be removed from the vehicle and you could put it on a bench, hold the unit in place with a clamp without damaging it then give you a better chance of wiggling it out.

[Jim San]

I'd be tempted to squirt a bit of plus gas or brake cleaner around the edges and see if it dissolves the crud.

[Stesaw]

I'd be tempted to squirt a bit of plus gas or brake cleaner around the edges and see if it dissolves the crud.

Was gonna say just blast some wd40 down the wire holes and around the edge then give it a go again.