My Unusual ribbon cable...
Posted: 08 Mar 2020, 10:10
Recently I tried to work out why my temp gauge didn't flash on start-up. I pulled the dash and found the middle contact was not attached. This is why...
Top is a spare part and dated on the PCB 1982.
Bottom is the part pulled from my bus no date.
Every photo I can find shows the temp gauge connects with the centre higher. Why are mine in a line?
Top is a spare part and dated on the PCB 1982.
Bottom is the part pulled from my bus no date.
Every photo I can find shows the temp gauge connects with the centre higher. Why are mine in a line?