Page 1 of 1
Replacing Pop Top Hinges
Posted: 26 Jul 2020, 22:57
by flz2020
I have a side elevating pop top and I need to replace one of the hinges . Is it possible to do this without removing the gas struts? I need to reposition the hinges as the old holes in the fibre glass roof are a bit rotten. Any recommendations on where I can source hinges at a reasonable price is welcomed also.
Cheers!
Re: Replacing Pop Top Hinges
Posted: 27 Jul 2020, 07:29
by Da dan
I found its easier if you take the rams off as then it will sit right as you mark out for new ones. Can you not just make a bigger plate/washers to fit inside to spred the load on the fibre glass roof?
Sent from my iPhone using Tapatalk
Re: Replacing Pop Top Hinges
Posted: 27 Jul 2020, 10:11
by flz2020
I can give it a shot. The reason I might just reposition the hinge is that the problem is that the previous owner did a fibreglass repair where the current hinge is which is now crumbling. The difference in thickness of that area also causes the roof to not sit straight.
I was under the impression that if you remove the struts they need to be replaced, which is why I wanted to avoid removing them but is that not the case?
Re: Replacing Pop Top Hinges
Posted: 27 Jul 2020, 10:40
by TONYT25T25
I noticed shortly after buying my camper that the end hinge on the roof was loose and either missing or the studs/rivets had given way. As a temporary measure I fitted nuts and bolts through the holes supported with washers. I was probably fortunate that it was and end hinge and I could get access both sides. The protruding thread was grinded back smooth with the nut and well greased each year along with the other hinges. Although intended as a temporary fit they have been there for six years so have not had to do nothing else apart from keep them lubricated. You could probably put a bracket inside instead of washers but that was all I had to hand.
Re: Replacing Pop Top Hinges
Posted: 28 Jul 2020, 13:42
by SeanMc1970b
Re: Replacing Pop Top Hinges
Posted: 28 Jul 2020, 13:46
by SeanMc1970b
I'm sure I got a set of 3 for £25, with the £25 ones being brass.
Re: Replacing Pop Top Hinges
Posted: 01 Aug 2020, 21:41
by flz2020
Thanks for your responses, Im going to try order a replacement hinge and make the repair by removing the struts.