Page 2 of 2
Re: Front nearside wheel binding
Posted: 09 Mar 2021, 21:28
by TONYT25T25
Where are you putting this grease??
Re: Front nearside wheel binding
Posted: 09 Mar 2021, 21:41
by crazyhorse
Sorry, brake cleaner on the new seals??
Re: Front nearside wheel binding
Posted: 09 Mar 2021, 21:50
by TONYT25T25
Good luck, although i have repaired in the past, I replaced mine with a new one which I bought on line, but there is a temptation to repair and fix which is the nature of these vehicles.
Re: Front nearside wheel binding
Posted: 09 Mar 2021, 22:04
by crazyhorse
Maybe should have done the same... will see
Re: Front nearside wheel binding
Posted: 09 Mar 2021, 22:11
by Oldiebut goodie
If the piston is that tight you may have a deformed bore due to overheating - depends upon how far the heat travelled. I have always replaced calipers/cylinders on brakes for best results.
Re: Front nearside wheel binding
Posted: 11 Mar 2021, 11:46
by crazyhorse
Hey guys. Cleaning up the caliper i have noticed 2 little holes at the back... is this a problem???
Re: Front nearside wheel binding
Posted: 31 Mar 2021, 07:12
by crazyhorse
Update..
Have replaced both pistons on the front brakes. The dust seal on offside had perished so i thought why not..
Very long and boring story short i decided to bleed the whole system... snapped bleed valves on back and had to replace rear cylinders and brake lines...
Anyhow, everything back on tight, bled system 1 wheel at a time until no bubbles. I have one of those 1 man kits with the non return valve.. but now i have a really soft brake... and travels a lot...
Any ideas