Page 1 of 1

Gearbox end cover gasket

Posted: 11 Oct 2020, 08:03
by T25boy71
Hi all doing some oil leaks on the gearbox and the end cove gasket looks to have been leaking for some time my question is if I remove the cover is there any thing that will fall out etc Image

Re: Gearbox end cover gasket

Posted: 11 Oct 2020, 08:22
by Mocki
Yes, oil I suspect if it’s leaking before you take it to bits

Re: Gearbox end cover gasket

Posted: 11 Oct 2020, 09:11
by T25boy71
Gearbox oil has been drained, I’m going to jet wash the muck of then surport the gearbox with a jack remove the gearbox mount lower the box enough to remove the end cover. Will any think from in side fall of it I do this ??

Re: Gearbox end cover gasket

Posted: 11 Oct 2020, 12:03
by Aidan
yep 
thrust washer on top of reverse gear, thrust washer shim on top of 1st gear and potentially 1st gear will fall out 
looks like the box is overfilled and parked nose down so oil has been coming out of the breather hole on the top, it doesn't take much to make things look wet
what was the drainplug magnet like ?

Re: Gearbox end cover gasket

Posted: 11 Oct 2020, 14:18
by T25boy71
Hi Aidan
I removed About 4lt of oil the van dose sit nose down the front is lowered the rear standard hight So it’s very possible that is the case
How much oil should be in the box And the items that may fall of if cover is removed do they just slide back on easy?
Thanks

Re: Gearbox end cover gasket

Posted: 11 Oct 2020, 14:48
by T25boy71
The magnet had so fluff no bits 
it a dog leg box and 2nd gear Is sometimes stiff till warmed up a bit

Re: Gearbox end cover gasket

Posted: 11 Oct 2020, 18:22
by Aidan
gearbox should only take 4 litres from empty, which is not the same as full to overflowing the filler plug, I don't have a 2wd diesel so I don't know where 4 litres comes to, probably about a slightly bent small finger below the filler hole

Re: Gearbox end cover gasket

Posted: 17 Nov 2020, 16:58
by steveo9007
Aiden,

Have you got a location for the breather hole on the back of the gearbox please. just wondering out of curiosity, thanks

Re: Gearbox end cover gasket

Posted: 17 Nov 2020, 18:11
by Stesaw
Mocki wrote: 11 Oct 2020, 08:22 Yes, oil I suspect if it’s leaking before you take it to bits

ooo sass  :rofl 

Re: Gearbox end cover gasket

Posted: 17 Nov 2020, 20:35
by Aidan
steveo9007 wrote: 17 Nov 2020, 16:58 Aiden,

Have you got a location for the breather hole on the back of the gearbox please. just wondering out of curiosity, thanks

looking at the end cover it is just to the left of the case bolt that is in the 1 o'clock position, 2wd same for both 4 or 5 speed versions, it's about 4mm hole

Re: Gearbox end cover gasket

Posted: 17 Nov 2020, 20:36
by steveo9007
Thanks you kindly Sir 👊