Replacing 10mm With 9mm Valve Adjusters in DJ2.1 Engine.

[Aidan]

Pelican in the states sell what they state are genuine Porsche ones, same as ours
link to Pelican

[Aidan]

GoWesty's solution seems to be to add a set of lash caps, and I pressume their set of screws, that's what they say is in their new build engines
lash cap kit

[maxstu]

GoWesty's solution seems to be to add a set of lash caps, and I pressume their set of screws, that's what they say is in their new build engines
lash cap kit

Yes. Have ordered a set.

[Aidan]

fingers crossed

[maxstu]

fingers crossed

Thanks for your help and support.
Have also order an auto diff sump plug kit.

https://gowesty.com/products/differenti ... ce=youtube

[silverbullet]

Pelican in the states sell what they state are genuine Porsche ones, same as ours
link to Pelican

20USD each. Plus shipping and duties. Not really viable and if they are Genuine Porsche that suggests that they are available on this side of the Atlantic Ocean.

Our neighbour at the works does CNC turning, I could work up a quote for decent quality ones, deep case hardened. VW were big on induction hardening for valvetrain parts (including cam lobes) but no reason not to do it by another means.

Otherwise it means putting them in a heatsink to keep the threads unhardened and the additional handling drives the cost up quite quickly.

Heat treatment costs are are horrific these days, they burn a lot of gas so minimum charges for good work are north of £180 + vat

[maxstu]

I had a look as the Pelican supply.
One common theme noted about the poor quality versions that fail prematurely. They all have tapered heads. Whereas the genuine VW ones don't.
Pelican are tapered. Gowesty are displaying stock with non tapered heads yet still aftermarket? Order in place.

Aftermarket 10mm on left after 1800 miles. Genuine VW 9mm for reference. But same shape as a 10mm genuine VW.

[Aidan]

I had a message exchange with Mark over in Holland at Dream and Drive, he builds 2.5wbx using GoWesty kit, he uses the ones from VW ClassicParts which he gets from his local supplier, he's not reporting any issues, and I know he's had engines back in the garage for servicing
Heritage say there's are the VWClassicParts ones IIRC
here's the link to dutch supplier Boelm
Slightly tapered head in pic which is lifted from Classic I think

[silverbullet]

The correct way to make them would be to use a deep case hardening steel. Have the threads copper plated to mask them off and prevent them becoming brittle when the heads are hardened.
But how much to people want to pay for them?

[maxstu]

Well l'm close to 100 quid out of pocket because of this. Plus the fuel economy drops considerably when they start to go.

The first signs are low tick over and poor fuel economy. Then suddenly, on a cold start up, the engine starts clattering like a gaggle of geese and performance drops. And then there is the aggro of replacing the damaged one.

Happy to pay a premium once and be assured the engine is reliable.