Lucky Spragg's engine upgrade

for questions and answers about alternative power transplants on the T25, GTi, Porsche,Subaru etc, this is the place. You must register to post but anyone can read.

Moderators: User administrators, Moderators

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Lucky Spragg's engine upgrade

Post by silverbullet »

This one has been on the cards for a while...
Anyway, it finally arrived a few weeks ago and typically I am overloaded with work again!
Made a start, makes such a pleasant change to be presented with a clean engine to begin with.
Its an early suffix B (thin bearing) DG running twin carbs and making circa 94 bhp on the rollers, very impressive but customer would like a bit more torque.
So its going 2.1 and will be tested on efi before it leaves me and then will be re-tuned by a third party.
Pics:ImageImageImageImage
The engine is in superb condition, piston skirts are unmarked, flywheel is like new.
Image
Just a couple of studs to swap, oil pump is A1 (engine runs an external oil cooler) and the water jacket seals are original VW. You never see them like this.
Image

Schnippzle
Registered user
Posts: 715
Joined: 28 Nov 2020, 16:36
80-90 Mem No: 17435

Re: Lucky Spragg's engine upgrade

Post by Schnippzle »

That looks great!  What a pleasure to see a good unit.
1988 Caravelle - FB25B - Syncro converted
2016 MB E63 AMG S - The daily driver
2019 Harley Fat Bob - The leisure
ZsZ wrote: WOW! thats seems simply not right.

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Lucky Spragg's engine upgrade

Post by silverbullet »

I have split the case to let it fully drain overnight, the cam followers are perfect and unworn and the cam looks to be quite reuseable in another DG.
Its actually a bit of a shame to be opening up a perfectly good engine (but the iffy head studs would have let it down eventually)
This engine has definitely been very well looked after for its entire life so far.

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Lucky Spragg's engine upgrade

Post by silverbullet »

The case gets a hot ultrasonic clean and a few iffy studs swapped while its all toasty!
ImageImageImageImageImage

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Lucky Spragg's engine upgrade

Post by silverbullet »

This is going to be the last "suffix B" wbx from me for a while, so let's go out with a bang!
Brand new crank, pistons and liners from Classic (and a set of rebushed early rods with the re-useable non-stretch bolts)
Image

Schnippzle
Registered user
Posts: 715
Joined: 28 Nov 2020, 16:36
80-90 Mem No: 17435

Re: Lucky Spragg's engine upgrade

Post by Schnippzle »

Mmmmmmm, fresh parts :D
1988 Caravelle - FB25B - Syncro converted
2016 MB E63 AMG S - The daily driver
2019 Harley Fat Bob - The leisure
ZsZ wrote: WOW! thats seems simply not right.

Stesaw
Registered user
Posts: 1891
Joined: 10 Aug 2019, 23:30
80-90 Mem No: 17004
Location: Coventry

Re: Lucky Spragg's engine upgrade

Post by Stesaw »

Breathers on the rocker covers I see, would there be any benefit to doing this into a catch can along with the oil tower?
1985 LeisureDrive 2.1DJ 5 Speed syncro conversion project.
1979 LT 2.0CH Westy project

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Lucky Spragg's engine upgrade

Post by silverbullet »

This engine is fitted with twin carbs so the breather arrangement is a bit different to that for a 2E3 or efi.

Lucky_spragg
Registered user
Posts: 9
Joined: 02 Dec 2018, 11:01
80-90 Mem No: 0

Re: Lucky Spragg's engine upgrade

Post by Lucky_spragg »

All,

This is how I ran her before the refresh, both rocker covers and oil tower vented to a CB breather box, then to top of carbs. There are 6 entry points to the breather box so 1 spare that’s blanked off.

Will continue to use this afterwards too, not sure if it helped any but every little helps! 


Image

Schnippzle
Registered user
Posts: 715
Joined: 28 Nov 2020, 16:36
80-90 Mem No: 17435

Re: Lucky Spragg's engine upgrade

Post by Schnippzle »

Mmmmm, lovely :)
1988 Caravelle - FB25B - Syncro converted
2016 MB E63 AMG S - The daily driver
2019 Harley Fat Bob - The leisure
ZsZ wrote: WOW! thats seems simply not right.

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Lucky Spragg's engine upgrade

Post by silverbullet »

Cam timing is a job best done on a cool, quiet Saturday morning ;)
New 2.1 crank, barrels and DJ pistons from VW Classic Parts, Grant piston rings (USA), Newman 2.1 cam, early conrods (recycled from a healthy donor!)
Cam gear is a really nice one, a late unmarked example that appears to be a "0" with just the tiniest hint of backlash :)
Image

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Lucky Spragg's engine upgrade

Post by silverbullet »

Coming together again.
Camshaft timing double checked, screws glued and staked for extra security.
Its always a little stressful when closing up but in these temps, you have to work extra fast to get everything torqued before the flange sealant cures...
ImageImage

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Lucky Spragg's engine upgrade

Post by silverbullet »

Valves modified for extra flow with 30 degree back cut after lapping in
Image
VW recon water pump rebuilt with a new seal (recent coolant weep from telltale hole)
Image
Looking more like an engine againImage

Lucky_spragg
Registered user
Posts: 9
Joined: 02 Dec 2018, 11:01
80-90 Mem No: 0

Re: Lucky Spragg's engine upgrade

Post by Lucky_spragg »

Thanks Ian,

Looking forward to running this in now, and getting excited about future journeys.

Proud to be keeping it waterboxer…………..bought from GoWesty in the US of A! :pimp

Image

silverbullet
Trader
Posts: 16302
Joined: 08 Jun 2009, 09:51
80-90 Mem No: 6908
Location: Surrey Syncronaut #156
Contact:

Re: Lucky Spragg's engine upgrade

Post by silverbullet »

About ready to test! Had a worrisome moment when it refused to raise any oil pressure while cold cranking with the plugs out. Turned out to be a faulty Mann 719/12 oil filter. Fitted a fresh (primed) Mahle OC203 and got an instant 45psi.
I think I'd better pop the exhaust on first...
Image

Post Reply