Hello
So due to the noise of induction when engine is at approx 3-4k rpm when under load up hills the induction noise is horrendous. So have bought these from brickwerks, (diesel snorkel and silicon induction hose) but wondered if there are any suggestions for attaching the bottom of the oval induction hose to the standard subaru airbox which is just next to the rear left light void? Anyone knocked anything up before to keep the scooby quiet?
Subaru engine induction pipework
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 588
- Joined: 10 Aug 2015, 06:50
- 80-90 Mem No: 14800
- Location: Peel, Isle of Man
Subaru engine induction pipework
1987 VW T25: Subaru EJ20 using RJES parts (If it was meant to go fast it wouldn't be brick shaped!)
- Aidan
- Trader
- Posts: 6557
- Joined: 11 Oct 2005, 19:21
- 80-90 Mem No: 742
- Location: Llanfyllin, mid Wales : )
- Contact:
Re: Subaru engine induction pipework
you will need something like this in whatever diameter the rubber hose is and a length of hose to connect to the airbox, I can't remember what the diameter is exactly, 63mm rings a bell
link
link
- syncroandy
- Trader
- Posts: 1857
- Joined: 18 Oct 2005, 18:15
- 80-90 Mem No: 851
- Location: North Lancs. UK
- Contact:
Re: Subaru engine induction pipework
I have the Legacy 98> airbox, located in the LH rear corner. I just used the stock T3 diesel bus 'snorkel' parts (see ETKA T2SY 22-23):
251129533B
251129535
068129623E
I did a minor mod to the airbox sikkaflexing in a suitable piece harvested from elsewhere on the donor intake system (IIRC) to allow it to couple snugly to the 068129623E.
251129533B
251129535
068129623E
I did a minor mod to the airbox sikkaflexing in a suitable piece harvested from elsewhere on the donor intake system (IIRC) to allow it to couple snugly to the 068129623E.
Syncrosport
Volkswagen Transporter, reloaded.
252 GC5 EJ25 AAN L90D
246 097 AFN AVL+ L90D
Syncronaut #004
Volkswagen Transporter, reloaded.
252 GC5 EJ25 AAN L90D
246 097 AFN AVL+ L90D
Syncronaut #004