Page 2 of 2
Re: WBX test rig
Posted: 24 Jan 2021, 14:09
by Mocki
Shame you held your phone in portrait mode for the video .....
Re: WBX test rig
Posted: 26 Jan 2021, 14:50
by DoubleOSeven
Sounds good - a deep resonance, gives you a good idea of the 'power'
Nice
Re: WBX test rig
Posted: 26 Jan 2021, 15:18
by silverbullet
I wasnt quite happy with the idle, put it down to it being a little low. As I removed the exhaust AFTER draining down the coolant and oil
I see.that #2 exhaust port is suspiciously clean...
Did an injector spray test and it had failed, also spotted that two were a bit wet i.e dribbly
So I swapped the lot, spray test again, fill up with fluids and...
I can almost balance a coin on the breather tower, but didnt have a 20 or 50, only a 10
Re: WBX test rig
Posted: 11 Feb 2021, 22:30
by silverbullet
Finally got around to playing exhaust Tetris and working out a way to provide storage that wouldn't affect loading, being as my engine stands and this are at a common height for ease of transfer.
The silencer and pipes were the biggest headache, must have turned that thing over umpteen times before the penny dropped!
I think it's worked out quite well, a few simple hooks and gravity does the rest. Just needs somewhere to hang the alternator and hose clamps to finish it off, plus a proper fuel tank!
Fuel tank will tuck in here: