So we buy quite a lot of bits from GSF eurocarparts and the like. Quality can be OE or pi$$ poor. Mr Baxter tends to sell the better quality ones but...
Hi
I went for a 150km run yesterday up narrow, winding roads. When I got back home, I noticed that both front wheel hubs were hot enough to fry eggs...
Hi all this is my last chance of solving this problem before i get a replacement engine.
As you know from previous topic i have rebuilt a JX engine,...
Sorry if this is a daft question and apologies I haven't got a photo yet but does anybody know if the replacement of the relay lever boot at the end...
Hi, can anyone recommend someone or a company that refurbishes/rebuilds Solex carbs? They're off a 1983 2.00 air cooled and are the original carbs. ...
Hi all 1988 1.6jxtd LHD
I have a brick werks 10x645 water pump belt fitted to my van I've taken all the spacers out of the pulley but it still seems...
Has anyone used Castrol Transmax EP 80w (mineral) in their 4 speed gearbox and if so was it ok ? Not sure whether to go down the 80w90 semi synthetic...
Evening, I am currently swapping my DF engine to a DG engine and it looks like I need to change the throttle cable as my old one has a solid piece at...
Hi, if my 1900cc petrol was to overheat does the water/steam etc have an escape route other than the half filled expansion tank?
I realise this might...
I have the standard Bilstein jack for raising the vehicle but it always makes me cringe when using even though it lifts the vehicle ok, my problem is...
I want to rotate my flywheel by a fifth of a rotation as the ring gear is worn in the normal crank stopping places. It has a dowel in the crank so I...
Hi,
Just fitted s new door card to my early slider, and the return hook latch thing (to keep the slider open) fouls on the card, threatrening to make...
Hi have a 2.1 mv engine that has a triple pulley fitted.I was wondering which Mark on which pulley do I use to time the engine up.And is setting the...
Hey everyone I have a T25 1.6 diesel JLX engine and I took it to the garage for a fuel leak, they said it was the fuel pump so they took the pump off...
How many miles is a water pump good for , mine seems to be ok still but I’m sure this will be the original one .Van has 290000 km on the clock now so...
I've got a new JP Oil Cooler and rubber O-ring. Having fitted, torqued to 25Nm put a new oil filter on and filled up with oil when I ran the engine I...
Changed my clutch slave cylinder this week - a painful job but got it done. All was well initially - clutch worked fine - but after a couple of hours...
So, here begins my Engine Rebuild thread. I am going to attempt to record each stage of the process as I complete it and explain what I’ve done in as...
I appreciate that the 1.9DG and 2.1DJ engines are different in terms of one being carbs and one fuel injection, different airboxes, air flow meters,...
Is it possible without removing dash in an automatic T25?
Haynes manual reads dash removal, master brake cylinder and servo out.
BUT this is for gear...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum