Club 80-90 Forums

Apologies if asked before, i've been trawling but can't find much specifics on this.

Van is a twin slider (no full length kitchen), Full width RnR...

Our usual mechanic has just gone off on long term sick and we need to find someone nearby to take care of our 1991 1.9 Diesel Holdsworth Villa 3....

Can someone tell me why some Devon full length elevating roofs have 3 struts, one at the front and two at the back as mine has and yet some roofs...

Hi, I need to replace the gas struts on my Devon poptop I have tried taking measurements but they all vary in length slightly probably because they...

Just checking new server...

Hi all

Welcome to summer! 

I was out in Saoirse, my bus, yesterday, going up and down a lot of hills. She could charge up steep hills at a good...

Hi all, does any one have a spare Servo and master cylinder lying around they could take some measurements from for me, mainly the distance between...

Doing checks on van, coolant, oil levels etc. Oil level was below minimum mark, thought that can't be right as the engine would have been clattering...

I have a new tank fitted to the van. If you brim the tank, it leaks through the rubber seal between the breather pipe and top of the tank - part 6 on...

Guys I have an lt50 horse.box I thought the water warning light was indicating low water So topped her up but was full The light stayed on I filled...

So the PO bought a Pict 34 4 to replace the 5, not sure if this was deliberate or a mistake, but the guy he paid to put it in has got it in but at...

Can anyone here recommend a garage that does full restorations. Ideally in Scotland but to get it done properly I'll go anywhere in the UK

I bought one of these years ago, genuine VAG stock but I am struggling to identify the Webasto model number to get a wiring or connection diagram?...

Hi, I’ve just replaced the N75 valve on our 1z tdi conversion - which was done professionally five years ago - and discovered that the hose coming...

Hi all, new to this so please bare with me 😳
I have a 1983 T25 Viking1.6 diesel conversion that's being dismembered and attempting to restore, wheels...

I have a 1Y engine fitted in my bus and its time for cambelt change. I don't know what the donor vehicle was so am asking if all 1y engines have the...

Hi all

I have electric power steering in my van with a smaller Mk2 Golf steering wheel along with saab seats which is good and knee clearance is...

Hi All,

It looks like I will be getting my carb rebuilt, and wondered if anyone has a working Solex 34 pict 4 carb to borrow or hire for 2 months?...

Found this online. It may be of use to somebody.

Hi, 

Does anyone have a leisure wiring diagram for an 87 westfalia club joker.
I am undoing a lot of previous owner's bodges.
Also enewing the whole...

Hey folks, I picked up a refurbished pair of these carbs and I am keen to get them on my 2.0 l  :D 

Firstly…. Anyone of you by any chance have a pdf...

Hi All,

I have a question about throttle routing from my mechanic.

Throttle cable guide tube routing above fuel tank.. Originally routed below the...

Hi my dipped lights weren’t working after flickering off whilst driving and occasionally working after switching to main beam and back a few time. I...

1.6 JX 1989 
I am I the process of carrying out the full heater box overhaul but am unable to purchase the (gold type) resistors BW nil stock .. can...

I recently replaced all 4 rear cv joints and when I took the truck for a test drive all was good until we got to about 45mph when a...

Having some trouble getting my 1.9 petrol with the pierburg carb to cold start. I think the problem is that the fast idle cam (which I think is the...

Hi - I replaced my door and rear speakers yesterday, van still had the stock Blaupunkt made in West Germany. I was never a fan of the Blue Dot as a...

A few years ago i fitted a full set of front end powerflex bushes, bought through this site with a discount from brikworks.
I was under the van...

I know what level to set, where to measure it from, and how to adjust it, but should it be measured with the float in place or removed? It must make...

Hi everyone. Although i knew my van needs some specialist welding and underbody repairs this has been  confirmed after taking the van to South West...

i already use some basic chopping board spacers on the back to bring up the saggy bottom, but front spacers are more involved than that, being not...

Just a quick heads-up to anyone running a VAG drive-by-wire engine including any 1993-2005 TDI (and probably later), or petrol engine from ~2000...

Quick tip from Covkid on preventing engine bay wires from going brittle. I use the same stuff when restoring valve radios because of its...

The textured ceiling covering on my Kameo is cracked and splitting around the central vent, probably due to past water ingress. Has anyone replaced...

I need some help please,
I have the above, have had the timing belt sorted by my local guru but we are struggling to get the correct v belt size for...

So discovered it's not a good idea...

After having the engine out (1.9 DG) to sort out the exhaust studs, decided to replace clutch plates, and have...

I've decided to rebuild a spare dizzie that has been gathering dust in a box. I stripped it down years ago trying to unsuccessfully fix a faulty hall...

Hi,

I've got a original westfailure table which swings out from above the cupboards. last year a washer (internal tooth spring washer I...

Hi All, 

Looking for some advice on my T25 westfailure high top. The groove the groove the pull out bed runs in had a plastic trim on the top and...

Hey there, can you look over my timing setup?
I'm having problems with the van stumbling under acceleration, with low power. But I want to make sure...

Morning all!

I’m after some help with the r&r bed hinges.

I’ve purchased them 2nd hand and they look
Like the justkampers hinges. However, they...

Help! Really struggling to find someone to set up my carb. Does anyone have any recommendations in the Leicestershire area?

Thanks

Sent from my...

Hi, I have wired up an aftermarket (Eluto, so might as well not have any brand) oil pressure gauge.

It seems to give reasonable values, but that's...

I have asked a question on the alternative engine site but really my query is not specific to my AAZ.

My gearbox will be with Aidan soon for some...

Currently on a 5 week uk tour with work dotted in between . van has been faultless untill yesterday when temp gauge became intermittent and lower...

Wondering if anyone has experience of these batteries. They're way cheaper than good quality LiFePO4 ones and would save a lot of space. One 125Ah...

My gearbox is going to Aidan’s for some tlc next month and thought was to get him to change the shaft so that I can fit a dual mass flywheel...

Moved to sales.

Hi all
My T25 is now in need of some minor rust repairs, seams maybe wheel arches etc., nothing too serious. Has anyone any recommendations in or...

Hi all

I have fitted a new waterpump to my 1.9 dg but it didn't come with the sealing bung for the extra hole .
I havent been able to locate...