Club 80-90 Forums

Thanks again, will have to have a closer look at the whole length, as visibility where it goes through the rear bulkhead is a bit restricted. Just to add, if the poly pipe is ok, will the hose I intend using (6MM) internal diameter fit tightly over it. Rubber fuel hose should be 5.5 or 5.7mm ID so ...

It is to stop fuel syphoning out of the tank when parked uphill.

Hi, does anyone have a working link to the idiots guide to testing the hall sender? Looking at other posts just return a dead link. So far I’ve tested that I get 12v at the positive terminal of the ignition coil and also get around 11v when testing the two outer pins of the hall sender connector. A...

They are all made by the same manufacturer, poor quality compared to the originals. Just find who sells them the cheapest.
Original



Replacement



 

The original exhaust quite efficient acting as a large expansion box, If you want a long lasting exhaust, then go for the original type stainless one. https://www.brickwerks.co.uk/t3-parts/engine/petrol/aircooled-engine/2-0l-cu-engine/exhaust-system/exhaust-silencer-t3-petrol-1-9-2-0-stainless-steel...

LeeCarey wrote: ↑08 Jun 2022, 18:20 Will do although that seems a bit further back from where the oil is ending up.

The problem is the cooling air blows the oil from the leak point to where the air exits.

 

First thing to check is the oil pressure switch is not leaking.

The black wires should be powered with the ignition on, they should connect to terminal 15 on the ignition coil. The red wires look like for the manifold and auto choke.

I buy lots of stuff from AliExpress. Any problem has been sorted straight away.

Best mount it on a turret plate through the floor. Protects the floor and insulation from the exhaust heat and from moisture ingress to the flooring. https://i.imgur.com/TBgbDhj.jpg If you are worried about pump noise, these pumps are much quieter. And you can run these heaters on much cheaper Keros...

I used a 2mm one.

https://www.ebay.co.uk/itm/313973442711 ... Sw1CZiaNeZ

triggermala wrote: ↑02 May 2022, 09:39 Are the early and later tanks identical in size shape etc except for the difference in filler neck diameter.

Yes, only difference is the filler neck hole.
 

Buy the later tank and filler neck, they are much easier to fit. As the holes don't line up properly, there is more wriggle room.

Michael4 wrote: ↑18 Apr 2022, 08:36 How do you wire an electric pump so that it is disabled in a serious accident

You can use an inertia switch or a tachometric relay.

Yep, the replacement pushrods are made of cheese. I use Facet Posiflow pumps. 1.5-4 psi version.
https://www.ebay.co.uk/itm/264183350102 ... SwD39eWNLs