Club 80-90 Forums

Ash, did you get tyres? I have 16x7 et 33. Am thinking 40mm studs with closed end nuts.

Yes Brickies just recently started doing 15&16” steels, weight rated etc.


Sent from my iPhone using Tapatalk

Thanks Aidan, as I don’t know how much was left in the box due to emptying it whilst on ramps I’m guessing that if it’s level I should let any excess drain out until level with or slightly under the fill hole. My slight concern is did I overfill by putting 3.5ltr in on top of whatever was left in it...

Don’t forget the new rubbers bungs in the top and use non perishable fuel hose for this connections as the cheap braided stuff rots in no time. It’s not that complicated to take out but helps to have either a scissor jack or trolly with some wood to spread the load[emoji2] Sent from my iPhone using ...

Elite don’t recondition as much as put a bitsa together and cross your fingers. Andrew takes great care and produces a highly professional and reliable machine. He took very good care of my van!


Sent from my iPhone using Tapatalk

Hello comrades. I have been finding a host of different data about my dilemma with no clear outcome. I’m running a 091 DT code gearbox on an AGG engine with diesel linkage and a diesel mount which sits the gearbox nose higher than petrol. When refilling with gbox oil should it still take 3 Lyra as p...

I have an AGG with DT code 4 speed and 205 80 14c tyres. Runs at 70 around 3500 rpm handles well.


Sent from my iPhone using Tapatalk

Grease in old locks and mechanisms can dry out and get non sticky. Coul try flushing with brake cleaner especially the spring Are near tgd hinge

Sent from my HMA-L09 using Tapatalk

I've decided to use the proper vw lower repair panel
Just don't want to weld it on too high and risk melting the westy stickers.

Sent from my HMA-L09 using Tapatalk

I know, that's the good thing about doing one side, it makes you realise the other is probs just as bad or worse. I'm trying to decide whether to fo what you've done or whole quarter.

Sent from my HMA-L09 using Tapatalk

Good job, doing the same just now. It's satisfying to get the JP and inner areas strong.

Sent from my HMA-L09 using Tapatalk

Coukd get this but £50.....

Sent from my HMA-L09 using Tapatalk

Needs a bit of tlc here..

Sent from my HMA-L09 using Tapatalk

Cheap, oversize panel.

Sent from my HMA-L09 using Tapatalk

Arch edge intact if rough.

Sent from my HMA-L09 using Tapatalk