Club 80-90 Forums

i invested in a gaslow refillable bottle last year so dont worry about the gas cost now. so my 6kg refillable bottle will do 3 nights just about. 6kg lasts 3 nights :shock: - Or have I misunderstood ? I used a SAFEFILL re-fillable bottle and was very pleased with it. Fill up at the LPG pump at the ...

Bet there's a way round the "T". I can't remember where the T is, but if you can a new tube from the bottle to the top by "pulling through", then one can worry about the T afterwards,

I'm thinking, if you can get hold of the top end of it, you could connect some new tubing ( securely ) to the old, then, from the bottom end, pull it through. E D I T = ps, this would perhaps be easier if the tubing was warm. If replacing the actual jets (recommended) don't buy "after market&qu...

Ha, Golf T for me too !!

I'm guessing, if you were to mount the unit inside the room, the only pipe that needs to go outside is the exhaust from the burner.

Cheers for the info Mark

You say you can get the Russian ones, how much to 80-90 members

Oh and how much is one of your re-furbed Diesel Webasto units (I know you can't advertise on here, but I can ask )

I just found some end user feedback on a boat forum HERE. They seem to like them. Plus there is a UK supplier posting on there = better to buy from a UK supplier than from China !!

I'm looking because my (hopefully) new van is a Diesel (the cooker and fridge can run off Calor bottles).

You can now get cheap (£188) 3KW Diesel powered cabin heaters from China like THESE.

I am generally very suspicious of stuff from China having seen some right tat.

Anyone got any experience of these units ?

itchyfeet wrote: whipped the cover off and between 0.05mm and 0.01mm so in spec.

Put the needle on in a further anticlockwise position.

Is this how i wind back the mileage also! :wink: :lol: I wouldn't know 8) What would have cause it to slip out of position? It won't have "slipped" out of position. I don't know why it's wrong, perhaps a previous owner has messed with it (clocking it ??) and re-assembled it wrongly? Dumb ...

Yes, it will be fine

1.5mm is good for around 19 Amps, a kettle is usually only 3Kw max = aprox 12 Amps

I replaced the Speedo able at the weekend and its now reading about 10mph too fast at 20mph. . Agree with CovKid = it's a speedo problem, but a fairly easy, though very delicate fix. Remove speedo. Very very carefully edge the "needle" over the top of it's "resting pin" Very Ver...

Sorry to hear of this Emma :( So yours sounds like the fairly common head to case seal failure, rather than a blown head to liner gasket. You know that I know how you feel, as I have just gone through pretty much the same. I went down the "fit a decent used engine route". I also went down ...

Well just put another 40 miles on it, fast A roads and country lanes, no issues. Coolant stayed at a steady level, no bubbles or owt. Not counting my chickens yet though, I will use over the next few days and put at least another 100 miles on it, just to make sure it's all good. However, it will be ...