Club 80-90 Forums

https://www.amazon.co.uk/gp/product/B08 ... UTF8&psc=1
went with this one and just finished fitting it .
Happy enough with it and hope it stays working .
thank you all for the replies and the information .

Thank you all for the replies . 
spotted this https://www.amazon.co.uk/gp/product/B07 ... ecda59cb4e 
For 100 pounds can’t go too far wrong , hopefully 

Hi ,  I am thinking of getting a Chinese diesel heater .
Anyone here recommend a supplier , have looked on eBay but none the wiser .
thanks .

y jimpainter » 11 Jul 2012, 19:55 1,Take off the sliding door track cover 2,open the door and slide it back until the door track runner is level with the cutout in the track. 3,lift door runner off the track and slide door backwards until it stops. 4, swing the door around (as in like a normal door ...

Out of work for the foreseeable future due to Covid 19 and have time on my hands . Need to replace the outer sill on the sliding door side . I have been putting off for the last 2 years or so . Need to take off the door for easier access , how do I go about it , it’s an 84 early I think. Thanks in a...

I got the clustermaster one over 3 years ago
and it’s still working fine .
Easy to install fitted in an hour or so.

Got at this at the weekend and fitted the new cylinder no problem .
No more leaks clutch is fine but the brake pedal just goes half way down and the van doesn’t stop .
Any idea what’s wrong , thanks .

Went at this today and all going well until I tried to tighten the nut on the hydraulic pipe . Just wouldn’t tighten , and on closer inspection the hole where the pipe goes in isn’t deep enough . It’s a jp products item , avoid like the plague in future . Anyway another one ordered just hope it’s a ...

thanks for the reply . Had a good look there and it seems that the
clutch master cylinder is leaking , not a whole lot just weeping a bit .
Will order a replacement and give it a go , sure what’s the worse that
could happen

Hi , I have an 84 diesel van and the last couple of days it has developed brake fluid leak . The reservoir was just slightly below the full level and the mat under the pedals was wet . Just above the pedals I could feel where I think it was leaking. It looks like an awkward job to do is it just a ca...

Good job , well done

Thanks for that . I have a few rusty scabs around there , might just patch it fo the time being until I get the motivation .

Sorry to be the bearer of bad news... https://farm5.staticflickr.com/4309/35660316090_71ae84a07b.jpg Passenger step gone! by Mark Shaw , on Flickr https://farm5.staticflickr.com/4329/36020004876_a664b0a6fe_k.jpg IMAG0007 by Mark Shaw , on Flickr https://farm5.staticflickr.com/4305/36019993076_408f8...

Use a large screwdriver to lever the cylinder
away from the starter .

Try tightening the cable tie another notch .
My blue beam stopped working and after tightening the
cable tie it was working again .
Have mine over 2 years now with no complaints .