Club 80-90 Forums

Just a thought Em, (and I really don't know a lot about it) does your solar charger have a reverse discharge protection to prevent it loosing battery charge at night. The thought that darkness will suck power out of your batteries is an odd one but I have read about setups that seem to include them ...

http://wiki.club8090.co.uk/index.php/Brakes_Rear_brake_servicing" onclick="window.open(this.href);return false; can be awkward if your drums are lipped and dont want to come off, getting all the bits back on the right way, damaging brake line if it's coroded and needs replacing can be a sh...

From memory the brown wire pushes on to a spade on the upper section of the steering wheel column then disappears down to the horn. I cant remember which route it takes though.

Reverse switch on the gear box is not working.

or tap a smaller size imperial socket onto it. Have a replacement to hand!

You could use a suction pump to remove the oil and never touch the sump. possible sludge build up. but give it a good run before you drain to get all the particles in suspension and I guess it should be OK.

I have a rubber boot over the positive connection.

there are two tanks header and top up, if you mean top up tank behind the number plate flap, this could easily remain unchanged if there is no demand for a refill from the system. check the header tank on the right hand side of the engine bay (with the dalek cap) for a better idea of the state of yo...

I think you mean the LDA on the diesel pump? these guys might do one for the AAZ. http://vwenginerecon.co.uk/" onclick="window.open(this.href);return false; What's up with your one? there is not a lot to them, a diaphragm which can split and a boost pin. I repaired my diaphragm with a bike...

garrytheskate wrote:Where did you get the cable from?

There are quite a few variations on left hand right hand diesel petrol etc, get it from brickwerks otherwise you will probably be going back and forth to the likes of GSF trying to get the right one.

Went for a teng one as I was over a barrel and needed one quick. It looks the part, and didn't snap the heads off which after the week I've had was well worth the extra! How do they get calibrated by the way? Is there any way to do it at home without a reference wrench?

watch from about 2:30
http://campervanculture.com/2011/02/how ... ttle-cash/" onclick="window.open(this.href);return false;

Nice one. I never knew such thing existed, do they have a mounting hole to screw it down? Cant see one in the pics.

I have gone down the route of a 13mm bolt washers X3 nuts to hold the outer, its a pain to adjust but once its done its not going anywhere!