Club 80-90 Forums

I'm in the same boat as you I was told to get some really good spray adhesive and that fleece is good to use. I've got to redo mine as the carpet we used is far to heavy, I was also told to make sure the ventilation is good as it gets damp with condensation and the glue won't hold. What website did ...

I would definately be interested in that I'm struggling to come up with my design even though I know roughly what I want .Would you be able to design an L shaped seat and kitchen unit for a high top ideally would like the bed to be a 3/4 but I need three seatbelts & do not want a buddy seat I wo...

I was wondering does anyone have an L shaped seat consisting of a 3/4 rock n roll & a corner section I did see one in a joker at Ikea warrington but only through the window. If anyone has pictures so I can work out how it should look I would be most grateful. Is it possible to have a three point...

Took out the back windows had them welded as needed bought a louvered window to put in the where the sliding window is and bought back four window seals as mine had all been cut advised that they are all cut as it was a panel van mine were too short by about an inch none of the rubbers fit and neith...

Thanks Fritz

Hi all can anyone advise which sealant to use to bond my new hightop on with and where is the best place to get it .
Thanks in advance Sas

Thanks Aidan is there anything else I need to look out for in my service
Much appreciated Sas

Thanks Ian & Aidan will be looking at it on Friday, checked the air filter before and noticed oil in it is that normal It wasn't really bad but then it hasn't been used very much looked like it had come from the breather tower
As you can tell not done this before
Cheers Sas

I am about to service my engine this weekend 1.9 dg bought new air & oil filters sump plug & seal. When checking the engine when we bought it looked at the breather tower and was told it should have a gauze in it, it hasn't went to gfsthey don't do it was wondering if anyone knows where to g...

Just about to order my rustoleum .I was just wondering how you measured out the paint & thinner and what did you mix it in?
Thanks for the advice Sas

Change of plans been reading the wiki all afternoon took the spray kit & the compressor back going with the roller. Hopefully with some alright weather this weekend i'll be painting my camper

Worrying side is I did & got two pairs maybe I should wear them both together

Thanks for that will look more closely next time

I was just wondering I know you can use a roller put what about spaying does it go on easily or will I make a right mess since its my first time. I've bought a spray kit and a compressor so any advise will be much appreciated thanks in advance Sas

What is the code for alpine white please as thats the one I'm after
Thanks Sas