Club 80-90 Forums

Thank you for your advice, will crack on and get them painted

Thanks for the video link 👍🏻 Would you recommend sealing the gaps or will it perform just as well without ? When you say wiggle room are you talking about when you have to re-attach the tinware to the heat exchanger outer skin ? If I welded the outer skin gaps to the inner exhaust pipes would that b...

Looking to replace my rusted out heat exchangers, looking at the aftermarket ones , the tinware doesn't seem to be completely sealed around the exhaust header pipes. Is this normal, I imagine there's heat loss bit not sure of enough to be an issue . Has anyone sealed them by welding or otherwise ?

My rock n roll bed foam and covers are need of replacement..any suggestions, preferably someone you've used and would recommend .

Has anyone used Castrol Transmax EP 80w (mineral) in their 4 speed gearbox and if so was it ok ? Not sure whether to go down the 80w90 semi synthetic route....

So thinking of removing the high top on my '83 T25......other than sourcing a used roof skin and welding in place, does anyone supply a flat low profile roof skin in GRP that could be fitted over the remaining stripped roof ? Don't really want to go down the pop top route.
Cheers
Martin

Anyone using a Powerspark 034 SVDA distributor on a 2.0 L petrol CU engine ? Wondering what timing figures you're using ?

What's the quality of the heat exchangers available like ? Are JK , Brickworks etc the same brand heat exchangers ?

The exhaust silencer/heat exchanger system on my air cooled 2L petrol CU is finally giving in to rust. The heat exchangers I will have to get from JK or similar but I was after advice on the silencer options. Standard box, stainless standard box or one of the quietpak systems ? Any advice greatly ap...

Does any one refurbish the CU distributer or is there a replacement? I seem to have too much play in mine and on idle the timing mark is very erratic....

need to get a set for my hi top holdsworth villa, what do people use and what are my options ??? cheers martin

found it ! thank you very much for posting that pic, it is very very small ! cheers !

cheers will get the fan guard off and have a good look at it tonight , thanks again

are my eyes failing or is the timing notch on the flywheel very very small ? having trouble finding it, any pointers greatly appreciated, cheers

another question which may help, if you upgrade from points to electronic ignition do you have to change the coil? if not then my points coil would be ok, does a higher resistance coil produce a weaker spark ??