Club 80-90 Forums

Oh, I see what you mean.

No access to Imgur ! That sucks

Imgur link to photos/ drawing

https://imgur.com/gallery/vw-t25-starte ... es-d35qFrv

And this … which is correct

Found this online and another Thanks

:( Hello all, My starter motor failed, got a replacement from Rhino automotive. Put Everything back in its place, mechanically. Electrically not sure, I put it back together same as the original wires.l, took photos. There are 2 terminals , is an empty terminal, I put the positives on this,(battery ...

Thanks, don’t know how the last owner got it trough the CVRT test

Old on the left and new on the right

Replacing headlights and noted one of the headlights is different (old one) than the other (new one)
Should they be similar?





edited to show images and how to by mocki

That’s great, thanks so much.

Thanks for the advice, and diagram.

May I in ask where you got the diagram?

The engine starts, runs for a little while and slowly starts to loose power and stops. This o-ring is for the cold start lever, lever work ok, just the bolt and o-ring popped out, pops back in again. I have a video, if I can figure out how to post it Here’s a link for now https://www.tumblr.com/noob...

Thanks for the info on photos, can I post video?

Another few photos

https://www.tumblr.com/noobyvan/7752969 ... adjustment

https://www.tumblr.com/noobyvan/775297008412000256

Hi All, 1989 T25, have had all fuel pipes, filter replaced ,banjo bolt cleaned out, no air locks, no leaking of fuel….but… So was looking at the cold start cable ( like a choke) and noted the bolt was popped out a bit,(see photo) and there is a little rubber seal on it, would this be causing be engi...