Club 80-90 Forums

Bambu A1 with Elegoo TPU95 on the external spool. Nozzle temp was 200C and bed temp 45C. I started off with a profile posted online and haven't needed to tweak it, which was a pleasant surprise.

I recently got some TPU filament, and while doing some work on the rear cross member I thought I'd try out a replacement for the insert where the heater pipes pass through. The original wasn't looking its best. https://lh3.googleusercontent.com/pw/AP1GczPZPvJ3hd05J9ReirhygAgMi8iynFnf6Yf8IoOvcqWOyxvL...

Loads of good info there

For the M pins it has

Connector M

Not normally externally connected.

M1 INTERNAL grey yellow to pins A9 and G7
M2 INTERNAL yellow to pin A21

Where would they connect externally... when I get the fusebox out I might have better sight of where they go.

I've wired in a external fuse and relay to get it working again for now - as I'll need to drive this week. A good used CE1 was about £40 and it took about 30 minutes to swap. AFAIK all the CE1 fuse boxes are identical. There's a few on eBay but they're at the £60-70 mark - have posted up a wanted ad...

Cheap fuse is a possiblity, it's different to the others so has been changed in the past (but not by me). Surprised it's melted so much but still hasn't blown. Going to check the routing of the loom for any issues as best I can with the dash in place. Plan for today is to to put a relay on the feed ...

Coming home earlier in the week I noticed my right hand headlight was out. Side light and main bean still working, just no dipped beam. I had a look the next day and swapped the bulbs to test them, both bulbs were fine. A voltage reading was fine until the bulb was connected when it dropped, which s...

I believe they should be:

Brown: - (earth)
Red: +
Grey/blue: light (+ when the lights are on)

So ignore the grey/blue and use the brown and red.

Looks like that could be an option, 175mm deep so might be a tight fit! Having the bluetooth monitoring would be helpful.

  There is a lithium under the seat option from Campervan culture , they are not cheap though. Have a look on their website  That's why I asked about the Fogstar which is the same height as the CC one. CC lithium Dimensions: L x W x H mm 260 x 160 x 210  210 mm is taller than the maximum 175mm quot...

Yep, might well give them a call. Currently have 15" ET31, so pretty much a direct swap.

Those Dakar wheels look good - here's another link - https://www.dotz4x4.com/EN/wheels/dakar They don't list the centre bore, but I'm guessing if you've fitted them then it was fine? I like the look of the black version as well, but oddly they don't list it as available in 5x112. Did you need to con...

Mine is blanked off. I didn't do the conversion, but it doesn't seem to be causing any issues. To be honest, I'm not totally sure on the function of the breather/evac line on the engine. Do the breathers on the tank mean it's not required (no chance of a vacuum in the tank as the fuel goes down)? Or...

Not my photos, but mine look pretty much the same.

Thanks for the acronym list, looks useful!

Yep, worth it for the piece of mind. Got the van back today so need to measure up and then get some ordered.

I have a friend who uses Heriot Hill for his T4. Last year I was recommended Donzlinz out in Broxburn who gave mine a once over, put it through it's MOT, then sorted some minor issues.