Club 80-90 Forums

The oil pressure alarm has started going off on sharp corners, is this an indication that I need to top-up? I honestly can't tell from the dipstick.

The horn on the bus hasn't been working properly since I have had it. Sound is poor and and it quite often doesn't even work when I press it.

Is there is something I should be looking at to fix? Or is there a simple upgrade?

Bear in mind I know absolutely nothing about electrics.

Really weird one yesterday. For reference my driver door has never locked, the lock button just dangles uselessly and the lock barrel in the door has never done anything.  So yesterday I got out and closed it behind me but when I got back to the van the door was 'locked', both inside and outside han...

Which Weber is it, the 32/36? For the basic setting it's two full turns out on the mixture screw, then alter with1/4 turns Thanks. I've noticed a weird 'whump' type noise a couple of seconds after I lift off the gas, could this be something to do with the mix being too rich or the timing being off?

Since getting my Weber carb installed it sometimes takes a couple of goes to start the engine, otherwise all running great and if I give it a little bit of gas on ignition it starts fine. I'm just wondering if the ignition timing might need to be adjusted? I've no idea what it's set to at the moment...

There’s also oil at the top, but I can’t see anything actively leaking when I run the engine.

Had a Weber fitted last week and the van has been going like a dream. Oil pressure alarm went off about 5 minutes into my drive this morning.

Look underneath and there’s oil p’ing out of somewhere. Any ideas?

Seems like a stupid question, but would a normal electrician be the best person to look at the electrics in the van? Or are there people with more specialised knowledge who could look at it.

My 240v plug is not working and I'd like to get a proper solar system installed with controllers etc.

I don’t know of anyone who actually got a Weber to work correctly on a DG without spending about four times what it would have cost to get the original carb put right. dells would have been a cheaper better idea . flog the Weber and call Bromyard is my advice  Had my carb refurbed last week and the...

We upgraded to one of Andy's Syncrosport digital dash's which is brilliant. https://uploads.tapatalk-cdn.com/20210410/dce2f319bdf343e4fda645c6e1d96344.jpg Sent from my SM-G975F using Tapatalk I think this is probably worth the investment, was it difficult to fit? What do you do about the mileage in...

Is it possible to replace the whole instrument unit in one go? My (Analogue) clock doesn't work, the temp/coolant indicator either doesn't have its pointer, or it doesn't work, some of the plastic has gone opaque and the whole unit is just a bit grotty. Is it possible to just swap in a digital clock...

Where would be the best place to install speakers in the back of an Autohomes Komet? I've got an image in my head of an enclosure I could attach to the bottom of the bed, just above the back seat, not sure if it's something I've seen or just imagining. The usual under rear seat option is not availab...

Does anyone have any idea what the below clip is for? There are two matching ones, one on each side, I presume it’s something to do with the bed but can’t figure it out

Thanks so much to everyone who took the time to respond, especially Mocki.

No surprise that switch gets knocked out when the belt goes, it's a tight squeeze.

maxstu wrote: ↑09 Apr 2021, 11:39 Happy ending?

No thanks mate, I'm too tired after driving my alarm-free, light-free, van around