Club 80-90 Forums

Fantastic work.

I did both my master and slave cylinders today as both were leaking and the clutch went to the floor when I went to set off recently. It took well under 2 hours including bleeding and I'm not the most mechanically-minded,

Sorry guys. I know it's in here somewhere but I can't find it and have my MOT in an hour!

Is the gear on the adjustment rod pushed up or down to tighten though the hole at the back?
 

Thanks Funkychops.

I suspect I over-filled it and just had petrol slowly seeping out of a full fill pipe. I'll keep an eye on it and drop the tank if I see it seeping again.

Thanks Stesaw

Advice from an early van owner who has encountered this would be appreciated.

It's an early van with a 70mm seal. Can these be changed without dropping the tank?
 

I smelled some fumes near the driver side door shortly after filling and found this. Is it a fact of life if you overfill or is it something that needs urgent repair? Is it a tank out job? https://uploads.tapatalk-cdn.com/20201010/e40a39d4f4cb4b790b20122f2f55e50f.jpg Sent from my iPhone using Tapatalk

TONYT25T25 wrote: ↑03 Oct 2020, 20:20 Know what you mean, the speedo cable does seem to be secured in different areas, mine is cable tied to the spare wheel carrier rods.

Might do that tomorrow

TONYT25T25 wrote: ↑03 Oct 2020, 18:27

Ciaraneng wrote: ↑03 Oct 2020, 15:26


Sent from my iPhone using Tapatalk

Is that a rub mark at the base of the anti roll link bar where it maybe making contact with something else

Yes, just rubbing against the speedo cable though so not moving anything
 

Other side


Sent from my iPhone using Tapatalk

Hard to tell if the Bush is worn but probably is since it drifted out of place.


Sent from my iPhone using Tapatalk

Thanks David. Managed it with a vice grips and a large shifters to rotate the connecting rod.


Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

My anti-roll bar has looked like this on the near side for some time. I have an MOT (CVRT over here) coming up. Is it a problem and if so is it just a case of loosening off the adjacent bracket and giving it a whack? https://uploads.tapatalk-cdn.com/20201003/eb8e07419d2b1588bf5299de90103417.jpg Sent...