Club 80-90 Forums

I cant remember which section it was in. Someone was recommending a ply supplier in the midlands who's prices seemed very reasonable so I bookmarked it.
I suppose ideally I'd like vohringer type formica coated but it seems a bit too expensive.

Oi, get back over to SBMCC. :mrgreen: Hi oldie but goodie. I bookmarked a post I found on SBMCC regarding a lightweight ply supplier a while ago and now I cant access it. Any idea why this would be? This is the page I've been trying to look at http://sbmcc.co.uk/forum/index.php?showtopic=24319"...

I pretty much figured the same thing. There is a cover on the bottom of the heater held on by six screws which when removed gives good access to these flaps. The flaps seem to act as a non return valve when the fan is on by the air pressure in the heater box closing them. The flaps are a push fit in...

Ive just taken my heater box apart to change the matrix. When I split the box apart I took out the matrix and the steel plate behind it cos it was coated in crud. 2 plastic flaps fell out from inside the heater box behind the steel plate and I cant figure out how they go back in again. Anyone famili...

Just an update. I have now changed the clutch release bearing, spigot bearing and the oil and the noise remains. So the noise must be coming from the gearbox. Is this likely to mean impending catastrophic failure or can I drive it for a while like this? The van has been in storage for 3 years thats ...

Could be a bad earth. Check the earth crowns behind the fuse box.

This place sells good quality welding gear.
http://www.r-techwelding.co.uk/index.php
Just bought a tig welder from them,

could be a bit of oil leaking onto the flywheel from the rear crank seal. this can cause the clutch to skip sometimes.

http://www.rooftent.co.uk/webpages/maggiolina.html" onclick="window.open(this.href);return false;

Or if machine mart is nearer, they sell a cheaper one.
http://www.machinemart.co.uk/shop/produ ... ad-remover" onclick="window.open(this.href);return false;

Ive had one of these for a couple of years. http://www.machinemart.co.uk/shop/product/details/cros2-contractor-150mm-random-orbital-sander/path/15-power-sanders-consumables" onclick="window.open(this.href);return false; Its been brilliant. Used it on a few cars as well as on diy and decora...

Thanks guys, I was hoping this was the case.

The gearbox in my van (5 speed) makes a slight rubbing/bearing noise when idling. The noise stops when i press the clutch pedal. Anyone any idea if this is likely to be the box or the clutch release bearing?

Could try these? http://www.alignmycar.co.uk/" onclick="window.open(this.href);return false; Haven't used them myself.

Mine did this. Turned out to be leaky turbo seals on the exhaust side. Mine had oil dripping from the joint between the downpipe and backbox as well.