Club 80-90 Forums

Thanks for the advice Kev, im in East Kent. Has anyone had any body work done and can recommend a company???

Hi there, Ive had an 88 T25 autosleeper hi top for around a year. Body work and inside are good but small areas of rust are appearing. Nothing major light, small patches of bubbling in a few areas. Around the very edge of wheel arches, some parts of wheel arch pannel seems and at the base along the ...

Hi there, just seen the pic you put up on your original post. Let me know if you have any luck with a replacement Im after one of those too. Its for an Autosleeper t25 (1988)

No, the housing around the cap has 5 screws in the corners. the cap and housing all seem to be one. Its not the same as the general cap on rainbowconversions.

hmm still looking....

Dont think I have the key for it, or at least none of the keys I have fit as the key slot itself has jamned. Looks rather corroded inside. Yes it is above wheel arch and has four screws in corner of housing so could try taking it out. Question is where to get a new cap? Breaking it in half? What sor...

My water tank lockable cap is stuck. Any suggestions / easy ways to undo it or remove it so can put a new one on?

Just back from a trip away, though not in campervan. Shall continue looking into getting that leisure battery.. Now where did I put those wires. ??? Thanks for the 11V info, I didnt know that

And to think I began by asking about a propex heater!

Shall have to draw to a close on this on going investigation. The camper and I are at different locations up to now have been relaying your messages by phone, shall have a good look myself. Your respray is really good. Very inspiring. I think your profile info said 850 and done this year in Wolverha...

the feed wire goes to the control panel? Is the panel water pump and fuses, 12 volt sockets etc?

Yes there is a 4th line in on the +ve of the starter battery dad thought it was from the cigarette lighter. Perhaps the feed from the aux then?

Ok, raining here so will have a look in a bit. Lets say yes that wire is there. That feed then goes to +ve side of battery and -ve goes to chasis???

ok going to find it, what next?

Yes found big thick wire in silver braiding coming from the engine, as well as a thick red one and a thinner red one on the +ve. One going to tow hitch? The both disappear down to hole in floor

Thanks, my dad is out investigating the wires now. Get back about that in a min. So the hook up powers the socket and lamp... the socket I knew The van has one spot light and two flurescent do you mean all of these would be powered by hook up?

Wow, great paint job you've had done! I saw the space for LB under passenger seat when first looking at the van, you say has wiring already, do the wires already come out to that area? When you fit an LB what makes the appliances stop drawing from the main battery? Also will the propex draw from hoo...