Club 80-90 Forums

Yep
Hi top removed, roof repainted etc
Ta

Hi Have an annoying water leak on the van. The leak is visible around the drivers side courtesy light switch. Removed the switch and the leak seems actually to be from just behind the dash lower bolt. Remove the bolt, no water from inside the cavity. Suspect the screen seal, though can’t see the tra...

nicq wrote: ↑10 Oct 2020, 17:18 Surely if you roll it all up on the pole there's nothing to hang down, just start from the bottom and roll it to the desired length?

Possibly, the main kador strip will then be rolled up, wouldn’t have thought it would then fit into the gutter..

Hi
Have one of these in the van.
Fridge works fine.
Freezer never seems to freeze..
Anyone have the same fridge?
Cheers

It’s weird how this awning leaves the black kador strip hanging down enough to foul the door.. Plus during really heavy rain ( not that we get much of that.. lol ) the gutter doesn’t seem to drain and the drips are annoying., After fitting the awning rail to the van the awning fits great, but then I...

Tried pole and clamp.. the Vango Faros awning I have had the sleeve for the pole on the ‘outside’ of the awning bead, so the awning kador strip sits underneath the gutter, just enough to foul the sliding door.. So fitted an awning rail to the high top of the van.. But now have the fact that it ain’t...

Hi
Bought some kador strip and 3 sections of figure of 8 to attach to my camper/ awning..

Seems a pretty crap system to me!!
The rain leaks past the strip, and also where the figure of 8 joins..

Can’t see how else to use this.. but will ask anyway!!

Cheers

Only problem with mine is that at some point over the last 30odd years the stock system was ‘modified’, so now have only one pressure switch, which am okay with tbh...

Oil and filter changed religiously by the PO every 6k, I’ve done the same so pretty much all I can do..

Changed pressure switch and no fault light.
Plan to fit a gauge..., added to the list....

Thanks!!

The short piece that’s braided kind of..
Mine looks decidedly tired...
I know normal hose might collapse so would prob need some kind of reinforcement..

Hi

The servo vacuum hose...


Brickwerks have none..
Anyone else sourced this hose or used a substitute?

Thanks

Took it out to give it a good examine, mainly to make sure it actually came out

Stuck mi finger over the hole.. lol

Fingers crossed...

Removed push rod tube cover and the pressure switch is badly leaking...Literally leaking with the engine stone cold so when it’s running...!! New switch comes tomorrow courtesy of Brickworks. Fingers crossed is the problem. Am loaning a pressure tester if the new switch doesn’t rectify the fault, ma...

I guess also is there a previous post on how to best check oil pressure..
I will of course search, just wondered if anyone knew of a previous one..

Ta