Club 80-90 Forums

I found the answer in a vw doc: it should be between 2nd and 3th gear.

Hi,

When my 5-gear is disconnected from the shift rod the lever is pulled out at max (between 4th and 5th gear). I have also an 3H 5-gear and this one is pulled out to the center (between 2nd and 3th gear).

Is this the normal behaviour for a DW gearbox?

Thanks!

Interesting topic. I have a new accelerator but didn't change the accelerator quantity. The problem was already there before replacing the accelerator but it's worse now. So this afternoon I'v changed the quantity from minimum to just before max and checking the influence: in first gear the car acce...

Hi, When I accelerate, the bus holds a couple of seconds before acceleration comes up. It's just like somebody is braking a little bit. Sometimes I can hear a "bang". Yesterday I've checked the pre ignition with a timing light. When I give gas, the ignition holds or even turns back before ...

Hi, All gaskets are allready replaced and all vac's are tested and ok. The idle cut-off is working correctly. But I think I found the problem. I tracked it down to the idling fuel/air jet. fuel-air jet.JPG The only "problem" was the top of the screw was broken so I've drilled them out and ...

Thanks guys but it's a weird problem. This morning I split the carb en cleaned the hole to the idle cut off valve and put them together: idle ok, cold and warm. This evening I start the bus: no idle. The weird thing is: last week I did also a split of the carb to check everything: idle ok. I drove t...

Hi, I'm new on the board. I'm a 33 years old man who drived a 1.6 TD panel van for 11 years. Now it's time for restauration. In the meanwhile I bought a high top camper with a 1.9 wbx petrol engine and pierburg 2e3 carb. I have renewed: - fuel hoses - pull down - checked vac and are ok - bought a ca...