Club 80-90 Forums

Thanks everyone. These were the welders I was looking at . I know not the top end of budget but need to go with what I can afford bearing in mind I will need to get other ancils as well. Clarke MIG102NG 90Amp No Gas MIG Welder 109.00 https://www.machinemart.co.uk/p/clarke-mig102ng-90amp-no-gas-mig-w...

Cheers all , think I will give it a go....

Post to follow on recommendations for cheap DIY welder

Hi everyone. I need to replace the lower front panel on my 81 reg Devon conversion. Seems to a common place for the rust to set in. See various YouTube clips where it is referred to as the bath as all the water collects there. I like the idea of tackling myself. Did a part time welding course at loc...

Cheers boatbuilder will take card off and see what I can get to ?

Capture_Camper Door.JPG Hi everyone Needs some advice if I may. Unfortunate damage to the sliding door this weekend. Damage is only to outside of door as per the attached image. Door still works fine. If possible I need to know what I need to do to fix it. Is it possible to fix it my self. I would ...

waltraud wrote:Buy an led strip and place in your old light then re wire. £5 off eBay

thanks everyone , good ideas there. Unfortunatley old light fixing in no longer there so needs a whole new unit \ light
Just Kampers don't do one in case any one tries them.

Cheers

hi everyone , looking for some advice on where I can pickup a replacement light for my Pop top roof ? Will be wired into leisure battery Orginal light in question is about 80 mm in length , and about 30 mm wide. Happy for any suggestions on improvements if anyone has discovered and using a different...