Club 80-90 Forums

We also had a problem with our window, the middle sliding window seal was perished and it was near on impossible to find the correct piece of seal to make it work. Also have a few pictures of that if you're interested

12mm ply and wood look vinyl

You can see the top of the unit here, we also had some water damage behind and in the sill, it was from the fridge vent!

Hope this gives you some inspiration

Chucked a throw over the old seat covers, also made some blackout curtains and bunting

Some areas on ours were replaced with other wood, this panel and the top of the unit. The trim wasn't replaced on the top

We put down wood look vinyl flooring

Not sure if this will work, we carpeted the seat boxes

Ooops! So sorry I'll pop some on now

We have exactly the same interior will post back pics later

lefty67 wrote:

Mooms wrote:its not letting me post my pictures, it's saying pixels are too high?

resize the picture in photobucket

I'm on my phone, not 100% sure how to do that

its not letting me post my pictures, it's saying pixels are too high?

metalmick8y wrote:is it wet above the rubber on the ally part and can you post a picky of the whole window from outside please
mm

Just seen this I'll see if I have a pic in the archive, the water was pooling in the inside aluminium bit, but seems to be seeping between the rubber and the frame

Ok this is where water has come in today, although it has been pooling in the aluminium bit (inside) this is a factory window, it's a caravelle

metalmick8y wrote:you could also be missing something obvious, post up a few pickies of it
mm

Will do

lloydy wrote:Cleaned the drain holes out?

Erm, where do I find these? We gave it a pretty good clean before putting it all back in