Club 80-90 Forums

Could someone advise how a passenger bench seat is attached in the front? Does it just bolt in and cantilever over the edge or is it supported underneath? Does it have to braced from behind and how is this achieved without a bulkhead? Any advice gratefully received to accommodate rapidly expanding f...

Does anyone know where to get the small torsion springs for door handle levers and if so the part no.?

I also need the seal, escutcheon and spacer for the outer sliding door handle...

Nope haven't tried it... yet. T'was the old man that mentioned it, I'll quiz him further.

I've heard that early (80's) Volvo spoilers fit the T25, not sure which model.
Being a bit of a tight wad and having the odd scrapyard close by, does anyone know if this is an urban myth or can I spend some old pennies on one that'll fit.

thanks for the replies. With one young un and 2 more on the way I don't have the luxury of space for 3 child seats and will have to get wet wandering round to the sliding door. At least i get to spend some happy hours at the scrap yard, might just find a modern 2+1 setup with integral belts that can...

Need some advice on bench seating in the cab of a T25. Are there seats that are a 2+1 or a bench completely across, or do both exist? Does the 2+1 have 3 seat belts and are they 2 x 3point and 1 lap belt? Do more modern designs fit? Has anyone fitted a modern 2+1 from a vito, etc. with the built in ...

Had this problem myself in the old mans camper. Stripped the carb and blasted the jets/needles with compressed air... sorted.

Thanks for the advice.

I'm currently looking to buy some Audi A6 wheels 7J x 16" 5x112PCD ET 35. Other than having to machine the centre bore for the front, do I need different wheel studs/nuts/bolts or spacers?

I'll also be lowering the van by 60mm (AVO kit), will there be any fouling?

Any advice appreciated.