Club 80-90 Forums

Using silicone hose from throttle body around engine bay to Maf, then using original Subaru plastic intake pipework running to Ramair foam filter behind light cluster as per Aidens suggestion.

My immobiliser is plugged into the RJES loom, and one of the transponder chips is taped to the ring that would originally have surrounded the Subaru ignition switch, now located in the engine bay, ( I have a spare chip) The immobiliser is active until I turn the VW ignition on, then deactivates as s...

I used all RJES kit to do my conversion, RJES labelled the modified loom with a tacho output, this allowed me to fit a cheap Chinese tacho off e-bay, looks good though.

You could be cheeky and contact RJES, you never know!

Hi, You seem to be getting on well! I did the same conversion 18 months ago myself, besides a few hiccups it went very well, the reversed manifold works well as I had no bleeding issues at all. If you have steel waterpipes check them, mine were perforated, I replaced mine with plastic ones. I has Po...

Only one solution really, Richard at RJES, he will point you in the right direction.

Mark.

I put a Subaru sport 2.0 in my van, goes like the wind,good on fuel as well, mainly RJES with a one off exhaust and induction mods, go for it!
Mark.

Also using RJES blue fuel pump, rubber mounted to chassis rail, is quite noisey though.

I have answer regarding my woes. I have a 1996 engine, a 1997 loom and a 1995 ecu. Richard at RJES identified the ECU, Transponder, and chipset that I require as my loom is set for all those items, he has also found said items on fleabay, I just need a couple of questions answered by the seller. Hop...

Hi Daz, I keep my van elsewhere so I cannot check the loom at present, but if memory serves me correctly there are 3 block connectors very close to the ecu in my RJES loom. I have found a 6V ecu with key immobiliser and transponder on fleabay and am considering going down that route, I will contact ...

Hi Guy,s Thanks for the info. My engine is from a 1996 Impreza 2.0 sport, the previous owner has told me that the car had no immobiliser fitted, I certainly was not given one, I guess that I need an ECU transponder etc to get it to run, I guess that my RJES loom will have the required connectors ( i...

Hi Daz,

You have just confirmed my suspicions!

I have no immobiliser key etc with my G8 ECU which explains a lot.

Is anyone aware of a compatible ECU that I can use or do I need a G8 ECU and transponder etc.

Many thanks,

Mark.

I have been installing a 1996 Subaru Sport EJ20 into my T25 for about a year now, but have failed to make it run, I have used RJES kit throughout, but the problem was that I bought the engine alone with no wiring or ecu! I have been unable to establish what is the correct ecu as the previous owner o...

Hi,
I am just finishing of putting a Subaru EJ20 engine in my T25, has anyone in Gloucestershire done the same that I can view just to confirm that I have done the job correctly?
Many thanks,

Mark.

Thanks Psychonaut,

I will be fitting my plastic pipes this weekend, just fitted my ferrules after heating the plastic pipes to pop them in, when cold they gripped nicely.

Many thanks that will be a great help.

Mark,
.